I just picked up a 5.3L Aluminum Long block With 243 Heads,
I don't know what way Im going to go with this build.
So I am going to list it as a 5.3L first if I dont get any intrest, I will bore it out Put new LS6 Pistons in it and make a Gen 4 LS1. I am going to include the Harness Adaptors with this engine so you can bolt it in to any 97-current LS/Vortec application. The engine had 16k on it when it spun a Rod Bearing...(Picks of the spun bearing included below)
Included:
5.3L Aluminum Block light honed and ready to go with ARP head studs.
Rotating Assembly will be digitally balanced prior to assembly.
New LS2 Crank 24X Reluctor With CL 77 Bearings
New LS2 Rods With CL 77 Bearings
Used 5.3L Pistons With Hellfire Rings
New LS2 Cam With New LS2 Timing Setup (3 bolt)
New LS7 Lifters
Used LS2/LS6 Ported 243 Head Set W New LS2 Valves Seals And LS3 Springs
(Mild Port Only On The 5.3L)
New GMPP HV Oil Pump
New 5.3L Balancer
NEW LS2 Valley Cover
Used LS2 Timing cover With Cam Sensor W New HB Seal
Used LS2 Rear Cam Cover W New CR Seal
Stock L92 Truck Pan
Vented Valve Covers
New Block Stud Completion Kit
Asking $3,375.00 for the 5.3L build or $3,750 for the 5.7L
Reply With Quote