Cam install made easy

[Flyin 1500]

I just wanted to say thanks to this site and the other ones for all of the info and tools that made my cam swap a breeze. Tims valve spring tool made the spring swap a breeze and dirt track racer 81's balancer install tool was easy. No grunting required. In case you were wondering I did ls6 springs with hardened pushrods, the comp cams trunion upgrade while I was there and put in a comp cams 212/218 low lift. Oh and huge shout out to Nelson tuning for the re-tune. I had used them 3 or 4 years ago for my base tune and just called them up for the retune and it was easy! Cheers!

[LOBO]

I just wanted to say thanks to this site and the other ones for all of the info and tools that made my cam swap a breeze. Tims valve spring tool made the spring swap a breeze and dirt track racer 81's balancer install tool was easy. No grunting required. In case you were wondering I did ls6 springs with hardened pushrods, the comp cams trunion upgrade while I was there and put in a comp cams 212/218 low lift. Oh and huge shout out to Nelson tuning for the re-tune. I had used them 3 or 4 years ago for my base tune and just called them up for the retune and it was easy! Cheers!

How do you like the cam? What did you put it in?

[Flyin 1500]

I like it a lot so far. 2000 ecsb 5.3L 4wd. Got a little bit of a lope on the idle....definitely pulls stronger. I have not put my foot in it yet...want to get a few heat cycles on the new springs....but it's snappier so far.

[Disney]

Quit pussy footing around and lay into it!