Time to spray!!!

[AFSP1211]

No pics yet. Just bought a N2O kit off a guy on PT.net. Should be here next week. Will update post with install pics.

[kerrige]

Wow should be fun.

[AFSP1211]

Wow should be fun.

I hope so. All I need to install my nnbs intake are rails and the X-link for the TB. Can't seem to find them used.

[canada4g63]

You get some traction bars? How much laughing gas you going to use?

[TXSZ66AVLANCHE]

I hope so. All I need to install my nnbs intake are rails and the X-link for the TB. Can't seem to find them used.

Buy new! Waiting is no fun lol what is your current setup?

[AFSP1211]

You get some traction bars? How much laughing gas you going to use?

No bars yet and my DR's are almost done so it's gonna be a smoke show. I'll probably get some caltracs this winter so everything's good for next spring. I'm going to start at 100 then bump it from there. I don't want to run more than 200 on this motor.

Buy new! Waiting is no fun lol what is your current setup?

I dont like waiting either but I'm on a budget and new is too pricey. Running a 5.3 bored to LS1 specs with ls1 flat top pistons. Milled 241's for 11:1 cr, 228r cam, PI 3000 stall, FLT lvl 5 4l65, trutrac w/4.10's and Yukon axels.

[03regcab sierra]

Should run good! I have a set of rails off a nnbs intake i can sell u for a good price pm me wat u think they are worth and ill get em shipped to ya

[TXSZ66AVLANCHE]

No bars yet and my DR's are almost done so it's gonna be a smoke show. I'll probably get some caltracs this winter so everything's good for next spring. I'm going to start at 100 then bump it from there. I don't want to run more than 200 on this motor.


I dont like waiting either but I'm on a budget and new is too pricey. Running a 5.3 bored to LS1 specs with ls1 flat top pistons. Milled 241's for 11:1 cr, 228r cam, PI 3000 stall, FLT lvl 5 4l65, trutrac w/4.10's and Yukon axels.

Cool, any idle videos? Any plans to swap heads?