Freshly done 862 heads-- ported/polished/milled

[oleshifty]

Had these heads done last year, have been sitting on a shelf ever since. (Do not come with the valve covers pictured...midwest grabbed those already)

These were done by the same guy that did Lambo's heads, but these have a little more work on them (he never gave me flow numbers on them, so I'm going off what I was told)

Heads were ported/polished/milled down ( .020 I believe)
Have a brand new set of Comp Cam dual springs with titanium retainers
Received a 3 angle valve job and cut to fit bigger valves (Intake Valve Diameter: 2.00 inches
Exhaust Valve Diameter: 1.55 inches)

I have a brand new set of chromemoly 7.350 pushrods for these to use with a stock base circle cam to compensate for the milling.


Selling these for down payment on a house. Not 100% sure what they are worth, just know what I have in them.
I can take more/better pics for anyone who is interested. These were taken real quick with my cell...figure everyone knows what heads look like.

I would like to get $1400 shipped out of these, I will accept paypal, won't charge extra for the fees.

[Frenchy]

You do realize these are more expensive than a set of PRC's or Patriot's right? Like I have $1150 in my Patriot LS6's, that's including being worked over again by hand, new valves and dual Patriot Extreme springs.

[oleshifty]

I realize that. At the time I got these, the PRCs and Patriots were a bit more money and most have a much higher compression ratio, which is why I went this route. These are a better option for guys trying to stay N/A. 243 based heads were just too low compression for what I was trying to do.

I'm open to offers, just figured I would start at what I had into them, especially since shops around here wanted around 1000 just for the machine work these have done. That doesn't include springs/valves/heads themselves. I'm sure there are heads for sale cheaper then these, and there are surely heads going for much more. Lambo has been down some pretty decent numbers with relatively small mods, so I'm assuming these heads flow pretty well.

[Botlfed]

Glwts, theyve been worked more than my heads i know that, you should try to find a flow bench and get the numbers, might help with the sale....idk

[oleshifty]

1250?

[oleshifty]

1k...need these gone asap, make offer if you're interested