problem

[michaelweston1@yahoo.com]

Ok so i have a really bad misfire, i just changed my plugs and wires and i still have the misfire... im wondering if it is the tune i got from nelson performance... does anyone know if it is common for coil packs to mess up? im ordering a new tune and im hoping thats it but it feels like its missing on more than 1 cylinder... has anyone had this problem with there tune before?

[Crazy Blu]

Just call Allen he'll fix any problem you have

[foggy]

if you still have the original pcm, install it and see if your misfire goes away.

[EmmerichLSx]

I just fixed the same problem. My MAF was dirty.

[Frenchy]

How did the old plugs look? If it's a tune issue they will tell you.

[michaelweston1@yahoo.com]

I just fixed the same problem. My MAF was dirty.

how did it feel when you were stopped at a light

[EmmerichLSx]

how did it feel when you were stopped at a light

I had no codes. It sounded like a wrx.

[michaelweston1@yahoo.com]

Just call Allen he'll fix any problem you have

I just ordered a new tune

[farmtruc]

Hey Michael,
A tune will not cause a miss. The pcm is there to dectect a miss, not cause one.
Before anything can be done, get a scanner on the truck and scan each cylinder for misfires, that will point you in the right direction.

Sending out a retune for a miss caused by some electrical component will not fix a misfire.
I see your retune is for gears, servo, etc.

If it does fix it, you will want to check and clean all the pcm terminals to ensure connectivity is good.


Remember, the PCM collects data from sensors, then controls devices such as transmission solenoids and injectors.

Once again, get a scanner, it'll tell you what cylinders are missing.

[michaelweston1@yahoo.com]

Hey Michael,
A tune will not cause a miss. The pcm is there to dectect a miss, not cause one.
Before anything can be done, get a scanner on the truck and scan each cylinder for misfires, that will point you in the right direction.

Sending out a retune for a miss caused by some electrical component will not fix a misfire.
I see your retune is for gears, servo, etc.

If it does fix it, you will want to check and clean all the pcm terminals to ensure connectivity is good.


Remember, the PCM collects data from sensors, then controls devices such as transmission solenoids and injectors.

Once again, get a scanner, it'll tell you what cylinders are missing.

Ok thank you... i didnt think it was the tune i was just checking before i go and have to spend alot of money... i am going to scan it this weekend.