Need a few parts for my ls2/l92 swap going in my 07 silverado classsic. Please e-mail me at: project_tsi@yahoo.com if you have any of these parts!? Thanks for looking!
-X-link 2.1 90mm throttle body adapter module
-cam and knock sensor extension harness
-MAP sensor extension harness
-Delphi to Bosch MAF adapter harness
-ls2/ls3 side mount knock sensors
-fuel rails for ls3 manifold, stock or aftermarket
-ls2 valley cover
07 4WD SCSB, LQ9/LS3 w/LS7 cam, LS3 intake,built 4l80e conversion,custom rear mounted TC78 turbo setup, ported exh. manifolds, devils own meth kit, WTA intercooler, aeromotive f-pump,True Trac, stock 3:42's, "new design" gray 20" american racing torque thrust ST's, 3/4" drop kit, painted grille, hids, welded roll pan, iss wing, Factory ss front bumper, TBSS SW, custom pioneer/infinity system with 10" JL sub
FYI you dont need a MAP extension harness, there is plenty of wire to reach in the stock harness just cut back some of the electrical tape and pull it out and re tape the harness...same for the cam sensor harness. You can also use your stock knock sensors, just tap the holes that are already there and screw them in
2006 silverado SS....Clifford Jr...turbo coming soon
1970 Chevelle ly6 swap....d1 coming soon
very nice to know! Thanks!
07 4WD SCSB, LQ9/LS3 w/LS7 cam, LS3 intake,built 4l80e conversion,custom rear mounted TC78 turbo setup, ported exh. manifolds, devils own meth kit, WTA intercooler, aeromotive f-pump,True Trac, stock 3:42's, "new design" gray 20" american racing torque thrust ST's, 3/4" drop kit, painted grille, hids, welded roll pan, iss wing, Factory ss front bumper, TBSS SW, custom pioneer/infinity system with 10" JL sub
Posting Permissions
Reply With Quote