where to buy transmission lines?

[SpecV44]

I think while installing my motor/trans I snagged 1 of my transmission lines and bent it where it goes into the transmission. I assume this because we never took the lines off the transmission/engine anytime, and we pulled the motor/trans from the silverado ourselves. So of course now it is leaking on the transmission inlet. The question is, where can I get them? Im guessing I can get them from GM, but I am unsure of the part number and cost. I tried searching on gmpartsdirect but that didnt help.

If it matters, they came from a 2002 silverado ext cab w/ 5.3/4L60E and a factory aux trans cooler.

Thanks!

[txarkitekt]

I do not think any local auto supply places sell them prebent like the dealer does. I know that it would cost about $25 if you buy standard cooler lines and bend them yourself. Unless you are good at bending the lines yourself and can flare the ends properly, I would just buy some from the dealer.

[SpecV44]

Yeah, I was afraid of that. I would do them myself, but I want to keep the factory line ends so I could use the clips that hold the factory lines on. Guess I will swing by the dealership tomorrow after work or saturday morning.

[randomhero]

You could make your own with some high temp trans fluid rated hose. Would be easier in the long run.

[sierraman]

if you know someone with a shop account you might get them a little cheaper. hope this helps you out
outlet (trans to rad) - 15773661 - 28.17
middle (rad to aux cooler) - 15809058 - 24.69
inlet (aux cooler to trans) - 15809053 - 32.72