I need to get the 12v + pin in my 7 pin RV plug powered up. How do I do this?
I need to get the 12v + pin in my 7 pin RV plug powered up. How do I do this?
01 ecsb 5.3 4x4 z71
Avalanche 17s and a pant load of miles
61 Corvette
350, 4 speed, 4.56's
32 Ford 4 door sedan
keeping it "stockish"
run a fused/ignition wire from the front to the back. gary
2005 SS AWD, 22" REPLICAS, VOLANT CAI, MAGNAFLOW EXH, 1/2 DROP- NEXT: TUNE, SHIFT KIT, SERVOS, TRU-COOL
(SOLD)2000 ECSB HARLEY DAVIDSON EDITION. 2''/4" DROP, 20" BUDNIKS, COWL HOOD, MOLDED ROLLPAN, CLEARS, DROP IN K&N, MIT, TAYLOR WIRES, LOUDMASTER EXHAUST
1991 RCSB S10 355 SBC, 700R4, 8.5" 10-BOLT, 18"/19" C6 Z06 WHEELS, 4"/5" DROP, MAGNAFLOW DUALS W/X-PIPE, FULLY SHAVED W/ CADDY LIGHTS: NEXT-LSX 370/PT88/TH350
Is that the charge wire? If the truck has towing package it already has the wire it just needs pulled from the tape holding it to the underhood harness and attached to the stud on the fuse panel. Also need to pull the red "dummy fuse" from the panel and put the fuse that comes taped to the loose factory brake controller harness in the slot where the dummy was. If it does not have the towing package you have to do all of the above plus run the wire.
It has the factory tow package. I'm gonna try to get it hooked up this weekend.
thanks
01 ecsb 5.3 4x4 z71
Avalanche 17s and a pant load of miles
61 Corvette
350, 4 speed, 4.56's
32 Ford 4 door sedan
keeping it "stockish"
Posting Permissions
Reply With Quote
