-
trouble codes
I finaly installed my obd port and took it to autozone . this is what the gave me. po135 and po102 . i did replaced the map sensor with a spare that i had before i go and spend on a new mass airflow. the blazer's gas milage has been bad lately,oh and it smells of fuel . maybe you guys can tell me something that will work. thanks
-
Well, the PO135 is saying the driver's side upstream O2 sensor is bad--so just replace it. And the PO102 is saying the MAF has low frequency. You can take a voltmeter and check to see if you have between 4 and 6 volts. If not, the wiring is bad somewhere--at the connector, in the wire loom, etc. Try looking at the connector to see if the pins are properly seated.
2000 ECSB 6.0L
TORQUER V2 CAM ● COMP 918's ● 7.4 HARDENED PUSHRODS ● K&N SERIES 77 CAI ● 80mm BBK ●PACESETTER LT HEADERS AND 3'' ORY ● SUPER 40 FLOW ● 3000 STALL ● 4.10s ● BUILT 80e ● VORTEC PERFORMANCE TUNE ● MSD 8.5mm PLUG WIRES● ELEC. CUTOUT ● UD & ALT PULLEYS ● FLEX-A-LITE E-FANS ● 22" CENTERLINE STINGRAY III's ● LUND FIBERGLASS TONNEAU ● 2" LEVELING SHACKLES ● 12K HID LOWS & FOGS ● LEDs ● DEBADGED ● WHITE-FACED ESCALADE GAUGES ● KICKER 450.1 ● 2-CVR 10's ● DS60's ● K693's
-
Sometimes 102 is caused when someone checks the air filter and does not plug the MAF back in.
Kinda need to know what vehicle you're working on.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Reply With Quote
