I dont know?

[2001silverado]

I bought a cam off ebay that came from a stock ls1. I want to send it to cam motion to get it grinded. I want it to have the biggest lope possible with out using a stall converter and with out upgrading the springs. Is this even possible, Im no mechanic by far.
Here is a few specs on the new cam and the stock one

1999 vette (new one)
207/199 .479/.472 117

2001 4.8 (stock one)
190/191 .466/.457 114


Thanks for any advice. Brett

[trever1t]

Not sure but i would think it less expensive to buy the cam as you want it, not re-ground, that's gonna cost a bit!

Interesting split on the vette cam, it'll prolly idle better than your stock 4.8 cam too.