Hey,
I have been doing a bunch of research in anticipation of the 5.3 swap I will be doing but never came across an answer for this. I have BRP/Hedman Husler headers available for the swap. Has anyone ran these with the dirty dingo mounts or is it possible. The truck is a 1991 c1500 rcsb. From what I see visually the BRP mounts move the engine further back then the dirty dingo's.
Thanks!
Last edited by 91rcsb; 06-14-2015 at 02:59 PM.
The dirty dingo's have some adjustment to them. On my swap I located them in the same location as my old 350 so all my driveline stuff hooked up correctly. I have Schoenfeld long tube headers.
Sounds good. I have the dirty dingo's ordered and the headers ready to be test fit.
Thanks
we used the dirty dingo mounts on the obs swaps that we have done along with the schoenfeld headers and the fitment was great
06 rcsb, 6two, 231/235, 4.11, pacesetter, 80e, 14 bolt, Nelson tuned
2011 rcsb 6two swap in the works with 6l90 and boost
FARMTRUC CAN GARGLE PEANUT BUTTER
Posting Permissions
Reply With Quote