i have a complete set of 5.3 LM4 pistons and rods for sale with about 20k miles on all. i have brand new total seal rings installed on them (previous rings were still pretty good but i wanted to put new ones they cost me 100 bucks) im asking 200 shipped for it all
Last edited by kha4079; 11-20-2011 at 04:38 PM.
ttt obo!
Those are flat top pistons. They only came in the 4.8 and the L33 5.3, unless you swapped them. I'd measure the rod and post it just to clarify for anyone.
cjriojas:if you're weather man is a 5 gallon bucket, YOUUUUUUUUUUU might be a redneck
danger_ranger83: I see now why it cost so much to get a harness made... FML
2boostedSilverado: I like Casey's rear end, I want to chat with him about it
thanks for the type-o they are LM4 pistons and rodsOriginally Posted by Duct_tape123
they came out of an 04 ssr 5.3 aluminum block.
Wish I had the spare money are you open to any trades?
99' Silverado RCSB Z71: 5.7L Iron LS1, 11.2:1, Custom EPS Cam, Ported 862's,Ported TB, E-Bay Cold Air, E-Bay Long Tubes, Dynomax X-Pipe Exhaust, Electric Fans, Innovative LC-1, Self Built 4L60E, Circle D Pro Single Disc, 4:10 ValueTrac
I'm finishing tear down of my engine tomorrow. Depending on how bad my cylinder is, I might pick these up from you.
10-4 guys im not really looking into any trades but i am up for some cash these pistons are good to go nothing wrong with them just a lil dirty on the surface the piston side coating is clean hardly any scuffs of wear and the rods look like new
Last edited by kha4079; 11-23-2011 at 06:19 PM.
ttt!
ttmft!
Posting Permissions
Reply With Quote
