+05 e-fans, nelson harness, 4l80e trans, hughes 4l80e converter, np263 transfer case

[350ss]

2003 GM Chevy 4L80E Transmission 2WD. 75K miles, worked fine when removed.

Asking $699 plus shipping



-------------------------------------

2005+ E-fans and nelson harness both new in box

Nelson harness ** sold**

***Fans SOLD***


----------------------------------

----------------------------------

Hughes 4L80E 3000 RPM stall converter with lockup.
Bought for a project but never used...fresh from Hughes has dual bolt pattern.
***SOLD***
http://www.summitracing.com/parts/HUP-25-30L/
----------------------------------

NP263 HD Transfercase and front driveshaft from 2005 Chevy truck with 18K miles.
Bought a pullout drivetrain for a swap and don't need the t-case.
***SOLD***
--------------------------------------

[polos954rr]

Clean parts. What did the Fans originally come off of? I have a 03' Slivy with the 5.3 just want to make sure they would fit my Radiator. Interested

[350ss]

The fans are brand new, not sure if they were factory take offs or if they were ordered from gm. They should fit any 99-06 truck with the larger radiator that measures 34" between end tanks (radiator core width).

[snowboardman137]

like a week too late or i'd have the fans and harness gone for ya... just put my fans and made myself a harness a week ago....

BUMP for good stuff!

[ducky]

damn good deal for the tranny and verter. If someone buys my FLT65E Ill buy that tranny and verter

[polos954rr]

I measured out my Radiator and its 28" core size. I don't think it will work unless someone else comments that I can use it. Bump for seller if not.

[bangbangskeetskeet]

I measured out my Radiator and its 28" core size. I don't think it will work unless someone else comments that I can use it. Bump for seller if not.

You need to either buy the large radiator or get a set of ls1 fans off an f-body.

[thunderwagen]

Is the trans slip yolk or bolt in yolk?

[Trevor]

IS the nelson harness the kind for a 1 pcm pin setup or setup to run both pins to the pcm?

[350ss]

I believe it's setup for one pin to the pcm and one to an a/c trigger.