ok heres the deal i have a 350 that i put a cam in with .498 lift on intake and exhaust i put double vavle spring on it would i need to get some stronger push rods i put one stock set in there when i cranked it bent them im not sure if the problems is the push rods are that i just had them to tight any suggestions
current mods: dual flowmaster exhaust headman headers no cats, k&n cai, nelson tune
it's a good bet those dual valve springs bent those pushrods. I recommend hardened chromoly pushrods
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Posting Permissions
Reply With Quote