Hate to do it, but what should she run?

[JimmyB]

06 Silverado RCSB 4.8, 3.73 gears, Pacesetter long tubes with full true dual exhaust through Magnaflow race mufflers, Cam Motion 221/226 .550/.575 114lsa, Comp Cams 918 springs, Comp Cams 7.400 hardened pushrods, Airaid Cold Air Intake
RPM dyno tune 306rwhp/290rwtq

And incase it matters, which im sure it does, here is my wheels/tires setup.
20" American racing RT-S wheels (chrome)
275-55-20 Cooper Zeon AT's

May be taking it to the track tomorrow so I would like to know somewhat on what to expect.

[ducky]

If you want to borrow some crummy stickes LMK. Well not crummy, but I hook on them

[JimmyB]

If you want to borrow some crummy stickes LMK. Well not crummy, but I hook on them

I highly doubt I will spin, cammed with a stock stall LOL. This thing is a pig until about 25mph. I need to make it out to ATX to check your truck out, I have never really seen it in person.

[ducky]

Eh it's nothing to write home about. If you can cut a good 60, maybe low 14s, high 13s. Im so bad at this guessing game

[JimmyB]

I dont see it pulling a great 60ft, it will dead hook but it just doesnt leave hard enough. Until I pull the trigger on a stall atleast.

[danger_ranger83]

i say mid-low 15s possible high 14s

[Tank]

high 14's

Isn't those dyno numbers a little low??

[JimmyB]

high 14's

Isn't those dyno numbers a little low??

For some reason it was tuned on 87 octane.

[will_oh]

im with stunna on this one 14.3 @ 90mph. when are you gona run and where?

[CHEVROLADE]

14.3