lowering?

[socal1]

what kits are you using to lower your trucks. i already have shackles and am looking for a 2/4. what would be a good way to do so

[fishoops]

Save the hassle and buy a complete kit. Belltech is good and I think DJM makes some decent kits.

[ducky]

Mcgaughys spindles, Shackles and hangers, go ahead and do a C notch so it has more room

[gordo]

theres a lot of ways u can drop a truck
using kits like belltech and the others
if u want a 2/4 drop well all u need to worry about is droping the back because ur front struts are adjustable up to i think a 3" drop but 4 sure a 2" and the back u can either do a ghetto cut a leaf off the leafsprings drop it like that or flip the axle n do a lowering block kit on it using lowering blocks u can buy them at AutoZone for around $35

[Frenchy]

theres a lot of ways u can drop a truck
using kits like belltech and the others
if u want a 2/4 drop well all u need to worry about is droping the back because ur front struts are adjustable up to i think a 3" drop but 4 sure a 2" and the back u can either do a ghetto cut a leaf off the leafsprings drop it like that or flip the axle n do a lowering block kit on it using lowering blocks u can buy them at AutoZone for around $35

huh? adjustable front struts? cut off the leafsprings?

a 2/4 get yorself some spindles and hangers (since you already have the shackles)

[gordo]

huh? adjustable front struts? cut off the leafsprings?

a 2/4 get yorself some spindles and hangers (since you already have the shackles)

taking off the a rear leaf is the ghetto way of doing it n what most shops do

[11 6.2]

or do like i did cuz im poor and cut a front coil, rear shackles and remove overload.

[socal1]

or do like i did cuz im poor and cut a front coil, rear shackles and remove overload.

im poor too

[zeake]

Before you do any of the above read the post in the link below. Strong bad information in a post above.
Collection of Lowering Notes and Best Practices - SilveradoSS.com