Cutting off exhaust pipe

[mnc2fan]

Not really sure which to post in.

I'm looking at cutting off the exhaust end that hanges out behind the rear wheel. Tired of looking at it, just so ugly with that thing hanging back there.

So thoughts on where I should cut if off at? And will it possibly affect the sound any?

I was just thinking of cutting if off at any angle at the end ___
___/
Pretty much like that. Just somewhere under the truck.

[Lowrado]

have a turndown by the muffler thats what i did for a while till i made a tip going out the side do u have an aftermarket muffler

[mnc2fan]

Probably do that. Cut if off by close to the muffler, and have what I cut off expanded on one end. And cut out the curve to use that as my turndown.

Its all stock for now. Muffler plan is a little ways off.

[Lowrado]

i wouldny keep it like that for a while your exhaust gases are building up underneath the truck and will get inside your cab and thats bad you dont want to be breathing that in

[mnc2fan]

Oh ok. I see what you're talking about now. I could even go ahead and use the exhaust pipe that I cut off and have that go to the side. Wouldn't look as good as a chrome or stainless tip.

[vista4.8]

Cut it past the axle where the pipe starts bending downwards, Thats what i did and you cant see it at all

[DamnYankee]

My 4" pipe is turned down under the bed and my twin Borlas I had before were turned down under the bed and I never had issues with smelling anything inside the cab.

[wyatt_450]

Cut it past the axle where the pipe starts bending downwards, Thats what i did and you cant see it at all

same here

[sprayedenali]

ive got mine dumped right after the muffler before the axel, it works fine

[Slimsilverado]

me 3 i have a super 40 in place of the stock muffler with about 18 inc pipe out the back of the muffler and turned down before the rear axel.......