Hello, I am the new guy on the block. I talked to Allen a few times on the phone about tuning my Silverado SS. He is a regular on the Silverado SS board also. That is how I found this board.
Hello, I am the new guy on the block. I talked to Allen a few times on the phone about tuning my Silverado SS. He is a regular on the Silverado SS board also. That is how I found this board.
2003 Nelson Performance tuned SS: MagnaCharger Radix w/ 2.75 pulley,
Yank Pro Truck 3000, Comp Cam 212/218 558/563 115,
ASM headers, MagnaFlow dual in/out muffler, Flex-a-Lite fans,
160 deg stat. And last but not least, JAG Performance built tranny.
Welcome. Good call on the tuning. Magnacharger leaves a lot on the table. Nice rims on that SS, what are your times? How do you like those JBA shorties? Did you notice any differance? I've been thinking about a set for my HD.
Mike
'02 1500HD, 6.0L, magnacharger, 2000stall, custom magnaflow with electric cutout, E-fans, Nelson custom tune, Auburn LSD.
'79 L82 vette, Summit 355, Dart Pro1 heads, Comp 274 cam, Holley TBI, Built TH350 with 2500stall
'93 Blazer, full size 2dr 4x4, new project.....
welcome. got anyor times?
Hugger Orange 99 SS Hardtop #756
485rwhp/440rwtq SAE
welcome, what rims are those they look bad ass. if you dont mind me asking how much where they and what size do you have on there?
1999 Pewter Z28
Sold - 2001 Onyx Black Silverado Stepside "Thunder"
I love that red , I bet they can see ya coming fo miles! Great truck!
2006 Superior Blue Trailblazer SS AWD, Stock as a rock
Sold: 2002 GMC Sportside Denali front end with a 2002 LS1, FLT level 5, Yank 2600, Trick Turbo, T76, Nelson intercooler, 60LB injectors, Warbro fuel pump, Eaton locker, Magnaflow, 3.42, Nelson Performance Tuning (speed density).
Sold: 1981 GMC LB RC 1500 2002 4.8L 4L60E 12 bolt 3.73 Richmond Lock Right AC PS Nelson Performance tuning
Thanks for the welcome.
Regrettably I do not have any track times yet. I should in the next few months once I get the truck the way I want it and tuned. I have a 3 inch pulley for the blower on the way and I will be putting in new cam/springs/rods in the next week or so. After that I am going to put on a NX 35-150 wet system and give it a 50 shot. What I plan on doing is doing a run without the 50 shot and then doing one with it and see the difference.
L82gofast, The shorties gave me a little more but not alot. If I could do it again I would go with long tubes. They are alot easieer to install and I like to do everything myself. Of course anything is better than stock.
01Thunder, the rims are Symbolic XR-5's the ran $390 apiece. Size is 20x8.5.
I appreciate all the comments on the truck. I look forward to hanging out and learning a few things.
2003 Nelson Performance tuned SS: MagnaCharger Radix w/ 2.75 pulley,
Yank Pro Truck 3000, Comp Cam 212/218 558/563 115,
ASM headers, MagnaFlow dual in/out muffler, Flex-a-Lite fans,
160 deg stat. And last but not least, JAG Performance built tranny.
Slim...I think we've seen your vid clips on here! Welcome to the site, you have a pretty wicked truck there!
L82gofast... ¿¡I thought you had headers!? Man with a set of long tubes I'd bet you gain at least .1-.2 more time! Given anymore thought to that front mount intercooler I was talkin to you about?
The superior man is modest in his speech, but exceeds in his actions. - Confucius
"He who asks of life nothing but the improvement of his own nature, is less liable than anyone else to miss and waste life."- Henri Frederic Amiel
'01 Chev Z71 LT - '85 BMW 745i TURBO - '88 BMW 750iL - '88 Ford F150 XLT Lariat - '79 MB 240D - '79 MB 280S Euro
'80 MB 380SE-5.0 Euro - '85 MB 300SD - '87 MB 300SDL - 1990 MB 300SEL - '91 MB 300SE - '91 MB 560SEL
Let's face it, the red hair... makes 'em wet.
Welcome to ls1 truck ,its a great site to be a member of!!!
99 Pewter SCSB
DJM 4/6 drop, Hotchkis front/reat swaybars,Hypertech power programer, milled & built heads, Accel wires, distributer,coil, Mass Air Flow Sensor(mti motor sports, Granatelli),Dynomax UltraFlow Stainless, 17x8.5 Eagle Alloys, Escalade door handles, Suburban front grille, with clear corners and billet bowtie,Street Scene mirrors, Cowl Hood
Hell Yeah it is!Originally posted by pewter99@Nov 13 2003, 01:13 PM
Welcome to ls1 truck ,its a great site to be a member of!!!
anyway Welcome
RChevy.48
2001 Silverado RCSB 4.8L
Current Mods
Flowmaster Exhaust
LT1 Fans
vette cam sitting in garage
Nope, still stock manifolds. I am worried about loosing boost with a set of long tubes. I can't get a smaller pulley for this thing(that I can find anyway) to make up for any lost psi. This M90 is pushing it for volume as it is on the 6.0Originally posted by Hit Man X@Nov 13 2003, 12:33 PM
Slim...I think we've seen your vid clips on here! Welcome to the site, you have a pretty wicked truck there!
L82gofast... ¿¡I thought you had headers!? Man with a set of long tubes I'd bet you gain at least .1-.2 more time! Given anymore thought to that front mount intercooler I was talkin to you about?
Still thinking about the intercooler or water injection setup
The truck sure does like this cool weather that blew in here today
Mike
'02 1500HD, 6.0L, magnacharger, 2000stall, custom magnaflow with electric cutout, E-fans, Nelson custom tune, Auburn LSD.
'79 L82 vette, Summit 355, Dart Pro1 heads, Comp 274 cam, Holley TBI, Built TH350 with 2500stall
'93 Blazer, full size 2dr 4x4, new project.....
Posting Permissions
Reply With Quote
