Looking for a good carrier unit so I can get the OBS back on the road. Let me know what you have available. BTW, this is the unit that has the C-clip axle and axles flanges bolt the wheel onto it rather than the full floating axle that has splines on both ends.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
I just sold my 14 bolt but i have a set of new 4.10 motive gears, and a rebuilt kit that's missing a few shims and seals but the bearings are there with gasket and all the pinion shims. Just in case you find a carrier without all this and need it.
74 Austin Morris Mini 1000 - Daily Coil Spring conversion, lowered, Disc Brake conversion
FOR SALE: 04 RC/LB Duramax -12 second tow pig, built Allison, Tune, and supporting mods
FOR SALE: 03 Silverado SS -DBRods built 40X, DP, Suspension. Going for fast
I will keep that in mind. I have a set of factory 4.10s out of a low mileage TBSS sitting on the shelf waiting for me to find a carrier.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
I have an open carrier in the rearend I'm using for my OBS build, I plan on swapping it out for a G80. Let me know if you're interested.
1991 Silverado-L33 5.3L, 212/218 .557 .562 115+4, ASP under drive pulley,180* thermostat, 90mm truck intake w/ LS3 throttle body. Shoenfeld conversion headers and duel Flowmaster exhaust. Performabuilt LVL 1 transmission and 23-2500 stall converter.
Posting Permissions
Reply With Quote