need help asap DBW-DBC conversion

ok so ive looked and read all over the net and lt1swap, either im not understanding or just totally confused. Im tryin to convert my dbw to dbc. reason is because when i bought motor the dbw was takin off the intake and i didnt get the pedal or tac. the guy i bought it fromfelt bad because someone had jacked my throttle body pedal and tac so he lowered the price to 400 and gave me a dbc TB. so now im tryin to figure out how in the world to convert it. I have the 12200411 pcm red and blue plugs so i know that pcm can be flashed for dbc. I just need to understand how to plug my dbw harness to the dbc TB. something about tps to oil pressure, or 02 sensors and thats where i get confused. pictures, diagrams, anything to help me figure this out would be greatly appreciated.

Connector C1 is Blue and C2 is Red.
C1-8 Gray is TPS 5 Volt Reference.
C1-60 Blk is TPS Low Reference.
C2-24 Dk.Blu is TPS Signal.

C2-76 Lt.Grn/Wht is IAC Coil "B" High.
C2-77 Lt.Grn/Blk is IAC Coil "B" Low.
C2-78 Lt.Blu/Blk is IAC Coil "A" Low.
C2-79 Lt.Blu/Wht is IAC Coil "A" High.

Jeff

If you're swapping this into an 03+ truck, I'm going to stop you right now.

The engine is goin in a 94 c1500. Its an 01-02 engine.

Then it should have had a dbc to start with

It came out of a Tahoe, it was the higher end one fully loaded it has dbw. I'm really not makin this stuff up lol. I know my pcm works I looked it up on lt1 swap its a 411 computer and I compared computer boards so I know that it will work and need flash I just want to know how to convert it.

Youd be better off changing harnesses.

if you already have a dbw harness, find a tac module and pedal. swap with someone who has a dbc harness.
or find the male-end connectors for throttle position and idle air control; and wire in with the diagram lextech gave ^

Quote:

---

Originally Posted by dickwiley

I just want to know how to convert it.

---

OK, So was your question answered?

Jeff

I only have harness, and I have a dbc TB that was givin to me. So id need dbw TB pedal and tac. Thats more money than I wanna spend just for that when could be used for something else.

Jeff, so I'll have to do is cut plugs of the dbw harness for throttle body add the wires you have shown with new plugs and I should be good

The DBW only has 2 wires going to the PCM. The rest of the wires in the DBW T/B connector go to the TAC Module (If I remember correctly). So, you need to run 7 wires from the PCM to the IAC and TPS.

Jeff

Quote:

---

Originally Posted by Lextech

OK, So was your question answered?

Jeff

---

yes sorry for delay been busy, and yes makes question is answered. Went junk yard and git the connectors I needed for the tps and iac and will wire in soon.