Printable View
I was going to ask this, seems like it would be easier to tie that in with the arming button on the N20, that way you got one less button.. It can be monitored through the interceptor to verify that the IAT is reading the correct degrees, and the advance can me watched also to verify it is pulling the correct amount of timing out...Seems easy enough..Quote:
Originally Posted by mean05
it's very easy to do Jon and doesnt take to long to install
Only one tune at a time, but yes to get the most out of both....LOLQuote:
Originally Posted by duckysbht
Seems like it might take 30 min with mounting a relay and running some wires, and about $6 worth of parts... Then I have to get my tuner to change the tables....I think they are set to pull 4* right now at that temp...Quote:
Originally Posted by mean05
just after you hook it up unhook the power to the noids and watch the scan to make sure it's seeing the proper IAT and pulling the timing like it should....on your shot i'd pull 6*
Change "AIT" to "IAT", remove the apostrophe and capitalize Ohms, and tell people that "C" is current (in this case B+) and I have no problem with the schematic. :LOL: Wanna see if I can look up temp vs. resistance for the IAT? Oh yeah, the ground symbol is asymmetrical....:spit:
Thanks V, we will pull atleast 6*. Since that is what is pulled right now. I will probably do this tomorrow evening...I've always wanted something to restore the lost power of the N20 tune...been looking at timing modules and they all seem to do the same thing. This is just homemade....LOLQuote:
Originally Posted by mean05
Not my schematic....:argg: its borrowed from another site...All I did is copy and paste sir...:naughty:Quote:
Originally Posted by GasGuzzler
Just joshing bro. Sounds good. Need the chart?
Sure..post it upQuote:
Originally Posted by GasGuzzler
Nathan Please!!!!!