Printable View
SC, I do not wanna see this motor f-ed up in any way, so with my modest knowledge of this stuff, please wait to about 750-1000 miles before you romp on it... I am sure that most automotive manufacturers put each and every motor that is dropped in the assembly line has about 10+ hours of run time before it is placed into the vehicle...but this is heresay, and we all know we think of that...
Yes, some say do it, some say don't...
But you have to push it a little--kinda like SC is doing to around 4K--to get the heat cycles up so that all of the motor components (e.g. rings) find their set from the intermittent heat cycles...
For that much money, I would go light for 2500mls.
See what I mean? There is no right answer!
The correct answer is the procedure that your engine builder recommends to keep your engine in warranty.
2 45 minute runs at operating temp, cool completely between runs.Quote:
Originally Posted by RedHeartbeat
Check.
and thats it so go hammer on it with a smile!!!!!
your running behind:lol:
No crap dude! your burnin daylight! Go do it!
Drop da hamma & hold on tight! :cool:
You should have stomped on it a long time ago SC, just keep an eye on that wideband.