Printable View
I am starting a new project it is a 2003 Sierra V6 that will be getting a LS1 soon but for now I need advice on wheels.
Which one of these would yall like to see on the new truck? Im going for the Corvette Theme
THese are all corvette wheels so I dont know if they will fit but I think I can adapt them somehow
http://66.56.95.102/z061.jpg
http://66.56.95.102/z062.jpg
http://66.56.95.102/z063.jpg
http://66.56.95.102/truck1.jpg
http://66.56.95.102/truck2.jpg
http://66.56.95.102/z063.jpg id say those if you were going to lower it any.
Good luck searching! I have been shopping around for some for my truck and they only make them in five lugs so far. If you find them let me know.
You're going to need about 2" of spacer to bolt those onto your truck axles. Motorsport Technologies can build you adapters but they are major pricey going from 6 to 5 lug.
How well do they hold under torque? I had some on my 97 mootang gt and when I was doing a burnout for the ladies at our civic center my drivers rear tire shot off at bout 200mph.
http://66.56.95.102/z061.jpg
I like these.
Yea I found the 2" conversion adapters for 100 each but wont that put the wheel to far out fo the fender
Vettes have a way positive offset. I have 2" spacers on my 93 to fit the 18x9.5" vette wheels.
i like em :thumb:
What you need to do is measure the distance from your stock wheel's mounting flange to the outside wheel bead and compare that to a Corvette's offset.