Post it up Kurt!

...:yawn:....

Agreed

i heard something about some pretty quick passes... idk though

Okay... Ran 4 times... 1st pass didn't time the run (idiot in the other lane staged passed the beam, I wasn't going to wait for him to figure it out, I said farch it and went). I lost 2nd gear after the 1st run and some soft launches... other than that I'm happy with the shakedown runs.

All I have is a GoPro vid from the 6.6 @110 1/8th... 10.1 at 140 1/4, 1.7 60ft pass. And I'm finding other vids as they come in... found 1 with the 6.9 @112 1/8th... 10.3 @ 142, 1.9 60ft pass.

http://www.youtube.com/watch?v=X2X4-...layer_embedded

http://www.youtube.com/watch?v=IPpprtUPNBU

bet it felt good just to go down the track again after the past few years. Not bad for shake down passes, good luck on getting it sorted out

what trans are you using???

Congrats Cuz!

Thanx! A th400... not sure if it was the trans or the shifter yet? I'll check it out sometime this week... and make some other changes also to get the 60ft down a bit.

Here's the slips

1.91 60ft
4.72 330ft
6.92 @ 112.87 1/8th
8.79 1000ft
10.38 @142.23 1/4

1.74 60ft
4.44 330ft
6.68 @ 110.59 1/8th
8.59 1000ft
10.19 @ 140.93 1/4

hmm... so am i crazy or do i only hear one shift?

^^^Yes... I lost 2nd gear...

Found another vid... didn't do good work in the burnout box...

http://www.youtube.com/watch?v=OeAKSp_nUKU