fuel line quick disconnect - male end

found the right quick disconnect ends that will go to the fuel pump, but i cant find a damn male end that would go into the OEM fuel line that usually connects to the fuel pump.

anyone know where i can get one that isnt an AN fitting on the hose side? to keep the cost down im really just interested in running some high pressure fuel line. can anyone point me in the right direction, or maybe show me a different way of doing it? i really dont know what to do with the se plastic fuel lines. i wish i could just flare it and clamp it:rolly:

http://www.summitracing.com/parts/RUS-640940/

???

that has a AN fitting, then just get one that goes from AN to a barb, and run your high pressure hose as planned

damn, so nobody makes on that is just barbed? is there a better way aka cheaper to do this lol. it seems like a waste to buy fittings to fit the fittings

Go to Oreillys or Parts house and get fuel injected hose. Take a razor blade and carefully cut the plastic line off the factory fittings. Push the Fuel injection hose on to the factory fittings and there you go. No clamp needed

Quote:

---

Originally Posted by DBRODS

Go to Oreillys or Parts house and get fuel injected hose. Take a razor blade and carefully cut the plastic line off the factory fittings. Push the Fuel injection hose on to the factory fittings and there you go. No clamp needed

---

when you say cut the plastic line off of the fittings, do you just mean the quick disconnect part, or the actual plastic fuel line. i didnt look at everything close enough when i had the bed off. no clamp sounds scarry:hyper2: will it hurt anything if i do throw a clamp or 2 on there?