Crank remover and installer tool

hey guys, my crank pulley puller broke, the rod bent after many years of service.
I can't buy just the rod, I already tried buying a 5/16 stainless rod, it bends, can't get 5/16 in hardened rod. anyone have the PN for the GM crank puller.
I'll post a pic if you don't know what it looks like.

also, my threads are messed up on my homemade crank pulley installed. I use a long bolt, washer, etc, to install the crank pulley.

Anyone have the crank pulley installer part number?

i know you do GasGuzzler.

thanks,
allen

the kent tool part number is for the puller is J41816 and the installer is J41665

Allen, we used a puller from Sears, and it was better than the Kent stuff. It would lock down on the pulley. I'll see if I can find a link.
Here is link if it works. KD Tools Posi Lock 2 Ton 3 Jaw Locking Puller - Model KDS3612 at Sears.com
We did make a little spacer that fit in the hole and used with it though.

Looks like you have your information Allen. If not PM me and I'll send you my phone number to get it over with...

Quote:

---

Originally Posted by trtturbo

Allen, we used a puller from Sears, and it was better than the Kent stuff. It would lock down on the pulley. I'll see if I can find a link.
Here is link if it works. KD Tools Posi Lock 2 Ton 3 Jaw Locking Puller - Model KDS3612 at Sears.com
We did make a little spacer that fit in the hole and used with it though.

---

Effin A--$92? I guess so... I have broken 3 different $20 pullers on one pulley before. I'd rather pay $100 and have the pulley off on the first try than pay $60 and have it take 3 hours...

In 4 years, we only used the one. We have used impacts on it and pulled hundreds of pullies and it did great.