intake manifold torque sequence

does anyone know the torque sequence for the intake manifold?

Yeah--do what Quik said--but don;t tighten down ALL the way on the first pass. Just get them snug the first time, then really tighten them down on the second pass...

x pattern huh? i guess ill try to figure it out lol

I made a little picture thing in paint to assist in my describing, lol. See it below.
Here's what I did and it hasn't fallen off yet!
Start at bolt #1, go to #8, back to #2, then to #7, down to #4, back to #9, then #5, #10, #3 then finally #6.
Torque them to 44inch pounds the first pass, then do 89 inch pounds on the second pass. If you don't have a torque wrench....estimate.
Hope this helps...

Attachment 579

Tanner---WTF??? Are you 4 years old? Nice picture douche. And could you make it any more complicated???? Its a simple X pattern.

But still...thanks for giving him step-by step instructions...even though I drew a better picture when I was 3 years old...

lol no offense on the drawing but couldnt you put the 2 where the eight is and so on.. instead of saying number 8 goes second and 6 goes third lol. thanks man it helps alot!

idk, i just woke up and started making it in paint.
oh well, unappreciative bastard tyler...lol

Man - shake that Etch-A-Sketch up and start over...lol

Whatchya runnin - Etch-A-Sketch 2.0? :lol:

(Tanner firing up his "computer"):

http://luscher.org/art11/2006.10.13_...etch_crash.jpg

...and grabbing his "stylus" for those tedious drawings:

http://www.focusmerchandising.com/im...tchasketch.jpg

:lol:

Moze you nerd

thats F N FUNNY