Anybody have any idea where I can get this plastic 2-peice grommet? I checked the parts department at the dealership and they said that I must buy the whole harness for that piece. $500+ = NOT HAPPENING!!! Oh yeah, the truck this came off of was an 89 Silverado 1500 with a 350.
Pete
2002 Chevrolet Silverado
2002 Pontiac Trans Am WS.6
2004 Dodge Ram CCSB Cummins Turbo Diesel
1989 Chevrolet Silverado RCSB - Work Truck, Vortec 454 swap in progress :rocking:
1972 Toyota FJ-40
1963 Chevrolet Corvette Prostreet
Looks like you have one already. Take a heat gun and warm the glue up and you can clean that garbage out of the old one. Once you've run the wires through there and you know you're done you can fill it with silicone.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
I kinda broke it lol.... After I took those pictures I attempted to remove all that gunk and to make a long story short I no longer own that piece.
Pete
2002 Chevrolet Silverado
2002 Pontiac Trans Am WS.6
2004 Dodge Ram CCSB Cummins Turbo Diesel
1989 Chevrolet Silverado RCSB - Work Truck, Vortec 454 swap in progress :rocking:
1972 Toyota FJ-40
1963 Chevrolet Corvette Prostreet
Went through that (didn't break it though).
I cut a piece of aluminum the same rectangular shape drilled the same hole locations (for the (2) screws) and used the round gromet that was on the harness that came with the donor engine (LS1 F-body).
Check your local salvage yards. Can get another one without the complete harness. Just a thought.
Posting Permissions
Reply With Quote