Forum: Powertrain

is there a special tool i can use to line up the timing cover or can i just put the bolts in and go its a lq4 if that helps

Im tryin to find a cam for my stock 5.3 I want one thats real choppy. I have the stock converter. Any suggestions? ls6 cam? GM performance hot cam?

ok well i got a 4.8 silverado single cab 2008 and well my trans temp always when im playing races it gets up 2 like 204 and well its hot so what do u...

well i have put my lq4 back together and bought a beefier ls2 timing chain for it but there seems like there is alot of slack in the chain and i was...

Alright so about 2 weeks ago I installed ceramic pacersetter LTs and their Y pipe and got a nelson tune and it for sure woke the truck up alot, the...

alright well as the title says my check engine light is on. i just got my computer in and so everything should be good. well i have a code that says...

Guys, my rod bolts just came in this morning, bear with me as I don't know too much on bottom ends, But in the paperwork and torque specs it says I...

Anyone in the Dallas to S. Dallas area know where I can rent or borrow the Kent-moore front and rear cover installation and alignment tools for my...

Anyone ever remove the bottom part of the leaf spring? I have helper bags now and am wondering if removing that lower spring leaf would ride any...

I have had 2 inch lowering shackles on my pickup almost a year. Never noticed it before but my passenger side is 1 3/4 inches higher then the driver...

I have 4.56s now in my rcsb, and im still confused with the tire height situation. Im currently running a 28" tall tire. Could some one tell me the...

Im thinking of porting my stock heads on my 5.3 and would like to have a higher CR and i was wondering if much can be achieved with thinner gaskets....

Looking for a set of heads for the new engine setup. Looking at tanz post on different LS heads. 243's seem to be the most sought after head. ...

I know there are some people on her who have done this so could you help me by giving me a parts list and where can i get the full clutch setup

I have an 04 tahoe with a 5.3 and i just purchased a cam that is 236/242 .580/.590 with a 114 LSA, and i was wondering how well this cam will work...

hey guys, im thinkin of runnin spray... nothin real big just somethin extra... i have the 6.0 w/ a 4l80e, intake, and exhaust... what am i looking at...

I don’t know if anyone has ever had this issue but when I try to start my truck after its been setting for a few hours it turns over several times...

Were do I start, I'm planning a 6.0 this summer and I wana go fast, don't get me wrong I know you can be big and go fast, it's just not as easy. I...

Would the one out of my 99 Silvy work in my 04 Sierra? They both have the same push button 4wd panel. Would have to be programmed? :help:

Looking at this cam from VHP DUR @ .004" 272*/280* DUR @ .050" 210*/218* LIFT .551/.551 OVERLAP 46* LSA 116* "ULTRA TORQUE" POWER RANGE ...