Forum: Powertrain

What kind of oil consumption, if any, do all of you see? I've heard of our engines consuming oil when a good amount of power is made but I'd like to...

Just wondering how many of you have replaced the o ring in the oilpump pick up tube? And did it cure the lifter tick? Recently purchased truck has...

im trying to figure out what intake manifold to go with for my 5.3 build this summer. im going to have some ported and milled 862s, 226/230 cam on...

hey guys whats all needed to convert my 08 to cable tb??i want that better throttle response.

Does anyone know where to get a replacement of this part? It's the rubber boot on the shift cable (I think half looks like an accordian and half is...

would fuel rails and injectors off an L92 intake work on these NNBS intakes??

I'm looking to buy a circle D 3200 converter. I have not heard many things about circle D and would just like to know how everyone who uses them...

Guys, when I bought my truck it came with a single in dual out flowmaster that sounded ok, but since the cam and heads and removal of cats, its now...

Just wondering if anyone has any recommendations for a set of long tube headers that will fit an 01 2500hd 4x4 6.0L ? Been looking and havent seen...

What yall think?? Also will my TB converter be enough for it? I ran a TB stall behind a 223/226 in my 6.0, but the 4.8 is slightly torqueless...

i just got a good deal on some dyna teck headers but here the ? the out of an 07-2010 , do you think they'll fit in a 2000 ?

Everytime i go to put gas i can only put 50 cents before it starts flowing back out and on my truck. It takes forever to fill my tank up. Anyone have...

started her up and next thing i know i lose oil pressure and the oil filter is laying on the ground so guess my 6.0 swap came early

i might have a chance to get a 96 4wd sclb w/ only 55k miles on it! it has a 5spd manual and 7.4 in it, but the motor says vortec on it. is there...

Just got my 5.3l swapped 79 chevy out on the road to drive around a little and i noticed that when i am decellerating there is a loud rubbing noise...

i have an 05 silverado 5.3l with 4l65e. i just had the transmission rebuilt for the second time in 3k miles. the first time it was built the junk...

My yukon just triped 90k yesterday and i want to change my fluid and filter and instal my shift kit sometime before I go to the beach next month and...

Im graduating high school in two weeks. I have always been in to car and working on them so i want to be a mechanic but im not sure which direction...

hey guys i have stock lifters in my truck i know i need to replace them because i have a new cam 236/242 .580/.590 because they are ticking. i dont...

Ok so I'm somewhat new here and I've got a question about my tranny. The truck has 148,xxx miles on it and the tranny is starting to go. I had...