Forum: Powertrain

My '01 has the same brakes from when I got it off the lot. Goin on 51k miles. Seen Baer and while they're nice (and expensive) I don't want to have...

Yeah well I have the small factory one and wonder if I should toss another one inline with that one? Anyone done this?

hey guys i went down to the local driveline place here in orlando to see if they could make me a one piece aluminum driveshaft the guy there told me...

It's finally in and my trans is back to it's normal cooling temp of 140degs on the way to work. I have to say one more time: PERMA COOL TRANS...

Well yesterday, I was doing some maintenance (new shocks, oil, fuel filter) when I was making sure the fuel filter wasn't leaking after install, I...

It's set in stone. I'm getting an Eaton posi and gears. My question is, is going from stock 3.73 to 4.10 enough? Will there be a noticable...

Ok, i got my dunlops sport rovers installed today, 275/60 15's during lunch and when i took off, i could tell immediately that the rear was whacked!!...

I called discount tire yesterday and they were supposed to have my tires in , i was excited. So, they tell me that the PO for my order at kuhmo said...

I'll let you guys know how the transmission temperature goes. You can read the earlier post to see how it compares to the Perma-Cool cooler. I...

It's nothing fancy , but about time i get some new tires for the old beater. I decided on the on Kumho Ecsta STX I noticed a slit in the inner...

i'm sending that perma-cool pos back to summit, my trans temp hit 195 today, wtf, i just hope this one stay together, B&M Racing Super...

I keep updating you guys becuase i know a drivetrain vibe can be a pita. Well, Joe and I (well joe did) pull the pinion yoke last night and...

I finally got my new cooler in. My old one was leeking, it seems the fins separated some how and started leeking. What a :grr: mess it made too. ...

I'm interested in buying that gm hotcam this guy has and he said one of the cam mains ( i guess that 's what they are called, it sits on the cam...

So far I've had the ds replaced two times and balanced once, changed the tailshaft brass bushing, and has the pinion and ring checked. I still have...

Are the 5.3 and 6.0 exhaust manifolds interchangeable? Do the 6.0 manifolds flow more than the 5.3? thx

I finally unloaded the truck today from picking up the 6.0 Thursday. Unfortunatly I noticed that the heads have a few gouges on them. One around the...

Ok, so i called Denny's Driveshafts and I think they are the ones to go with. I told them i had an ls1, 60e OD, 4.10 gears, 10bolt, and a +-60"...

Well I took a gamble and lost. A buddy of mine had bought a 2800 Vigilante(used) some time ago and put it in his 02 Z. He had it in there about a...