Engine | Transmission | Drive Axle | Chassis | Fuel
hey guys i have a 99 NBS silverado ext cab stepside... im swapping in a LS1 and want to swap the cam for a decent lopey idle and im sure i will have...
I'm looking to install a new differential this winter and am wondering which one I want to buy. From what I can see it looks like many folks are...
how easy is it to install a posi rearend like an eaton do you just bolt it in or do you hafto worry about backlash and shit??? or is that just when...
anyone have trhe volant intake ??? how does it perform anyone have any comparisons of all the intakes???
picked up my cut-outs today and going to install them tomorrow.
I am planning for the 6.0 swap but i want a radical idle. I heard a few Z28s with the hotcam that had a good choppy idle which i tend to like. I want...
Any of you guys have any Exp with these Electric Seats? My driver seat has become loose. It will move front to back .25" during gear changes, stop go...
Do these have fuel filters some where else because I cannot seem to find the fuel filter on my cousins truck? :help:
Finally got a 14 bolt sf out of a 97 truck. The doner truck was actually a 1500 as well. This was good at first but after I started needing parts...
I am going togo ahead with the 01 corvette cam install this weekend. I have some comp pushrods, ls6 springs and an adjustable timing set. I was...
Ok, so I got a new trans and stall in my truck this weekend, and now the truck (01 5.3, stock) doesnt wanna go into 2nd gear at wot, it wants to down...
Alright guys this is my first post even though I have been reading this forum for awhile. I have a 2002 RCSB Z-71. It has the ls1 fans, 145 amp...
02 pcm going in tommorrow what are the real advantages of it? how much of a hp gain if any?
I got my 6L swap done last night finally. I swapped in another 4wd trans too. I missed my VSS wire. Any idea what its close to? Also, I have a...
I notice alot of people on this site has corvette servo's in their tranny. I was wondering what exactly it does and how much E.T. will it knock off?
just got the fans in theyre awesome.. i have some pics on my cardomain page i cant figure out how to post em so if u wanna see em go to the link
I just picked up a low mileage 5.3 today,(thanks Again 00GMCSLT :thumb: ) I would like to build a 750 hp :drool: Streetable(i use that term reeealy...
I am going to help a friend out this sunday to change the knock sensor since it is throwing the engine light on. How long a job is it, and how tough...
I know you can by the parts at a local store, but don't have one within thirty miles of the house? What kit did you guys use? I have seen them...
I recently purchased a 34" Radiator, 05' E-fans, and a Nelson Harness. But, I read somewhere that you might need a bigger alternator? I have no clue...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules