Forum: Powertrain

Im getting my exhaust done tomorow. Going with 2 40's flowmasters and running them back into the factory Y & tailpipes. Wanted to go with the super...

Hey guys as you know I did a cam swap about 2 months ago Stock p-rods LS6 Springs 218/228 .525 .525 112 LSA ...Everything ran smoothly until I...

How much compression would i have on an lq4 and lq9 if i put 243 heads milled to 30

Ok...I'm ready...... I have been rolling it around in my head for a few wekks now and have kinda thought of a STS Type of system that I would like...

Hey guys Hope someone can help, I Finally did it and bought a new baby, After 7 hard and fast years on the 2001 it was finally time!! Trouble is...

Hello. I can hear a clank that seems to be coming from the drive shaft whenever I start and stop moving. I also sometimes hear it when I shift...

I've been getting interested in autocross, and all I've got is a truck. After searching, I can't find anything on the forum about it auto crossing...

i just bought a used PI 3600 converter used, guy said it had 2,000 miles on it, said he put a new tranny in his camaro, and got a new converter, i...

Its time for some new shocks but i dont know witch ones to buy. what do ya'll suggest for the rear?

Anyone know if they are going to redesign the driver side header to the new dynatech style?

When i'm around 40-50 and slightly accelerating there is a whine from the gears. Is this normal or did I screw up. I put them in Monday and the whine...

i went outside this morning to go move my truck for the plow guy and my truck was kinda stuck where i parked it. so i tryed to rock it back and forth...

So my 03 Silverado 4x4 w/5.3liter wouldn't crank over this morning (and it's like 10 degrees and sitting in 4" of snow). All the accessories came on...

Just curious about EXACTLY how many grease fittings the front end has. I want to say there's 12 but I'm not sure. Need to make sure I get ALL the...

OK so the level 5 lost the 3-4 clutch packs today. My one option is to send it back to the builder. Expenses would be as follows: $150...

I hope I'm not about to ask questions that have been answered a million times. I've been searching for a while but never quite find the info I want. ...

When it shifts up or down shifts into 2nd gear the trans will slip when the the R's get over 4k at full throttle. I have 57K on my truck, at 13k the...

Wondering if there is anyone who can post a site to show you how to do a cam swap on the GenIII?

where is the best place to buy a 1-2 and 4th gear servo? shift kit? price? thanks. shane

Has anyone had any problems with these drain valves, I'm really looking into getting one? QuickOilDrainValve.com - the best way to change oil