Forum: Parts Wanted

What the title says I'm looking for a set of 38 lb or 42lb injectors for truck intake. Preferably plug and play if possible if not I'll need pig...

Need a stock y pipe with cats for my 2000 silverado. Lemme know what ya got? Thanks

Looking For 8.6 open diff or (g80). Let me know what you got. Thanks

Looking to trade wheels only considering I have brand new tires! I have the gmc oem 20that lots of nbs trucks are rockin... They are my favorite but...

need the spring anchor plates (mount on bottom side of axle tube) and the spacers (mount between ubolts and top of leafs) to fit 3/4 ton 14 bolt SF...

WANTED!!! anyone have a MAF for a 07 and up NNBS. mine screwed up when i cleaned it.

Looking for a 4.8 or 5.3. Nothen special just a replacement for a while

Looking for rear axle assembly to do the 14 bolt swap. Gear ratio doesn't matter but need it to be 2006 up rear end.

If anyone has a dipstick tube and dipstick off of a 5.3 I would appreciate it, the oil pan I got came off of an 05' Silverado with the 5.3. My zip...

Looking for a 6.0 block. No internals or anything I'd needed. Thanks

I am going to install my headers soon and want to make some more noise too. I have a very small magnaflow that will likely be way too loud for my...

Im looking to upgrade injectors and wanted to see about saving some money first. Im currently running the factory 24#ers on my 5.3 Wanting something...

i know someone on here made some bars like cal-tracs and was wanting a set if they still made them or if anyone has a set they would sell. my truck...

That pretty much covers it. i got pre 04 studs and now an 04 up block. no good!! haha. let me know what ya got. the meet got me itching to get her...

anyone know where i can find one?

I need a throttle cable for my blazer project. If someone has the pedal too, that would be great. Let me know what you got. Thanks, Brandon

does anyone have that plastic cover that covers the radiator/ radiator support for a 2007 and up silverado laying around? not sure the proper part...

Buddy blew out stock g80, need to buy a stock carrier to put back in it. Dont care if its a locker or open diff as long as it works. Let me know...

I need the spacer between the flexplate and crank for a 4l80e to bolt to an LS engine

really wanting it fully built motor/trans, cammed and stalled. willing to travel for the right truck, let me know if you have one or know anyone that...