Forum: Electrical

Hello all, I bought a Scan Gauge 2 last week for my Lsx 6.0 4l80e swap and I was doing some reading and wanted to find out if I can get the...

Ok guys same truck I was having the headlights issue with we got the heads lights to come on but now the fuel pump primes and the ignition relay...

Put a 6.0 in a 2000 v6 swapped interior and exterior harnesses to dbw, fuse box everything, ok truck runs like a champ but the headlights wont come...

I just bought an 01 rcsb 5.3 silvy. The speedo needle is not smooth as I speed up. I read where the stepper motors can cause this but I don't know...

Ever since the swap I've had no charge. Votl gauge will not ever rise to 14v. New batt and new wires. I've tried a new alt and same issue. Checked...

I have a 2003 Chevy silverado with a v6 5 speed. I wanting to keep it a 5 speed and like to keep it drive by cable if possible. if I can't I need to...

anyone done this, I would like a way around my p1637 generator L circuit code other than ignoring it through my tuner.

so i got my new hoses installed and system charged. ready to turn on the ac but i need my efans to kick on high speed durring operation. Im looking...

so im trying to get the ac up and running and i accidentally cut the original wires going to the compressor... but i think i figured it out. this...

I swapped a 5.3 into my 97 burb I need a wiring harness I reached out to nelson but they said it might be 3-5 weeks since they are training a new...

Ok guys i just finished my swap on my 03 silverado and i had to convert it into dbw bein that 03 and up are dbw and now this reduced engine power...

01 reg cab short bed LS1 swapped in in place of 5.3. When I got my truck back recently it had a LS1 swapped in 3 days before I picked it up. Was...

Ok I mentioned before I am no good at wiring and it bit me this time, I pulled 4lb's of wires out of the dash, mainly a/c and radio out of my 2000. ...

im working on removing my 97 5.7 vortec engine im going to replace it with a 5.3 need a little help fellas what size screw is holding the...

I am looking for a remote start for a 2004 Chevy Colorado. Does anyone have suggestions on what brand to look at?

Hey guys Ive been trying to get my PRNDL to work and i only have P,1,2 and 3,D,P,R wont light up. I have all wires from the PNP connector spliced...

This could not have been easier. Seriously. I ordered the stalk from thecruisecontrolstore.com and in about an hour I had it in. I even ran it...

I have a question on ecm's my truck is a 1999 classic it has the 350 vortec I know its not an ls but I replaced the motor in it and it came with a...

Trying to ditch some weight in the interior and already did a lot, attacking the column now and am wondering if anyone has done a push button...

ok so i have searched and there are a few threads on how to hook it up but i dont fully understand. yes i have the swap in and running. ...