Forum: Electrical

anybody have a wiring diagram of the guage cluster on one of these trucks...1994 chevy.. Thanks Flaco

I think my alternator went out. My battery light is on when the engine is running. I have a sound system with about a 1000 watt amp, a few gauges and...

Ok heres what i did i want to make sure its safe? My truck didnt come with factory fogs so i bought some and installed them i ran wires from the fogs...

Well, i bought a 2003 lq9 from a burned out Escalade and i'm cleaning it up and installing a cam. Then its going in my truck to replace my tired...

I'm rewiring the power window switches in my '85 C10. What kind of solder should I use, and do i need to use flux?

I was trying to install some HIDs on my gfs car(99 grand am), i hooked up everything to see if it would work, and it did. But when I disconnected...

Man I have 2 cam codes that want go away, P0342 & P0343. All started when I put in the LS6 cam 550/550 lift 211/204 duration 117.5 LSA. Original cam...

Vehicle: 1999 Suburban 1500 2wd 5.7L Problem: My mom's 1999 suburban's AC is doing some weird stuff! The blower motor works fine, it is somewhat...

...

I'm the guy with the questions about DTC code PO343(camshaft sensor). I finally fixed the problem. It was a bad new part(Advance). I finally replaced...

I am wondering what the best way to wire up the A/C in my 85 C10 would be. Just use the original wiring to the compressor and the cut-off switch? ...

anybody by chance know how to wire a nnbs guage cluster into a nbs harness? or possibly know how to find the pin-out diagrams so i could figure it...

About to do electric fans and go ahead and knock them out the way. Would 2 of these be suitable for my truck? i will be wiring them with 3 relays...

I read that some LS engines have given problems of cam sprocket bolts coming loose and can cause the DTC PO343 to set and if ignored can ruin cam,...

So I picked up a fan assembly at the junkyard from a 3.8l V6 Impala for $75.00 and installed it last night. I had to trim the shroud to get it to...

how do u do it and any one have the measurments for spacing

Truck kept showing po341 DTC, I kept clearing this code and it varied on when it would throw this same code. I finally pulled the intake and replaced...

I just changed the engine. It came with new sensors all around. But this error code comes all the time I start. With the HPtuner I errase it,...

I posted earlier about my fan speeds and got great response, but now I am having a hard time locating the resistor module. The responses said it is...

Anyone have one? I'm looking for the wiring info for the gauge cluster harness. A pin-out diagram or schematic would be fine. Thanks in advance!!