Forum: LSX Truck Conversions

So, I notched my frame and used the ls compressor. Goin to use my stock vortec harness to hookup my ac, 4wd and the tranny and t-case. I need help on...

Ive pretty much got everthing I need figured and know what to get. Just a few questions I have left. Seems like a 99-02 throttle cable works with a...

I have a 1998 z71 with 5.7, I want to put a 5.3 in it..I have the motor, harness, ecu and manifolds. I'm trying to get a exact parts list and find...

I am quickly approaching the end of my ls swap into my 95 2wd ext cab, but have yet to make final connections from the ls harness to the truck to get...

Hello first post here on LS1truck sorry if I am in the wrong thread! But to get right into it my 08 sierra appears to be suffering the dreaded AFM...

I am on my third swap and I cannot for the life of me recall where I purchased the adapter so I can use the oil sender sensor from the motor in my...

Im having overheating problems with my newly swapped truck. 1994 gmc 4x4 sierra z71 with 2004 gmc 2x4 2500hd 6.0/4l80e. I used the factory rad and...

Hey everybody! I'm in the middle of dropping in an LQ9 into my 2000 Chevy K3500 CCLB. Well, closer to the end. But there's one big thing that's got...

Hey guy's, first post on here, thanks for letting me join. I have actually looked around the www and lt1swap for hours and haven't found much for...

1994 silverado swap almost nearing completion,, I went to the junkyard and could not find a single throttle cable from a 96-98 vortec truck that had...

Need help on mating the 6.0 to the NV4500... My 6.0 came from a 2005 model C2500.. Looking for info on which flywheel/clutch/pilot...

Whats a good brand of piston, cam all the internal stuff that can hold alot of boost?

hey guys! my names tom.Im tackling a project for my dad that is long overdue. so long story short my dads turning 50 and having 4 sons hes really had...

Anyone know what adapters are needed to adapt the stock oil cooler lines from the LQ4 engine to the stock OBS radiator?

You guys that swapped LS's into your 4x4 OBS trucks, what are you using for headers? Trucks not lifted at all, will be using dirty dingo mounts.

I am doing a ls swap on my 92 k1500 Blazer. I am trying to figure out where the wires for the front axle actuator and the other plug that is there. ...

So I have a 77 K20 I'm building with a 5.3 from a 2004 Suburban. I'm running Schoenfeld Headers 1302LS1 as they're the only ones that don't rub on...

I was wondering everything I needed for the swap. I have a 88 c1500 just need any tips parts numbers whatever I can get would be helpful thanks in...