Forum: LSX Truck Conversions

Hello, I have a 1984 C10 with a lt1/4l60 combo and I am looking for a shop that does great work for a great price. I am leaning towards a full LS...

I’m wanting to compile a part list for everything I need for a ls swap in my 92 k1500 short bed I have around 4000 to spend, Id like to keep my 700r4...

Hello everyone I have recently bought my first truck back. It's a 1997 Chevy K1500 z71 with the 5.7 vortec. Being a young man at the time active duty...

So i bought a 99 gmc sierra nbs that had a 4.3 in it but was swapped to a 4.8 its been put in already but didnt come with computer so i bought the...

Hi everyone. I am almost done with the LS Swap on my 97 2 door. On the back of the engine up top on the drivers side, there is what I am guessing...

I keep getting code P0706 while driving my truck with a 6.0 and NV4500, Stock harness was converted to stand alone and combo installed in a 94...

I'm have been searching to find a answer for this and have came up empty handed. Where in the engine compartment of a 96 Tahoe can I find the wire...

My swap on a 93gmc with a 99 5.3 is nearly done, truck starts and idles fine but won't rev past 1500rpm? Then it starts to surge during idle, any...

I just finished my 5.3 into a 1993 sierra by combing through these old post, everything is here good luck

So bought a whole 2003 Chevy SS truck and took motor out of it and transmission to set into my 1998 Seirra 4x4 I kept the transfer case off of the...

Alright guys, never done a ls swap before. But I’m getting a 5.3 to swap into my truck and I will be keeping the 4l60 in it because it is built and...

Will a pre ls transfer case work on a ls era transmission

I have a 96 that I already did a 411 swap on. Now I'm swapping in a 5.3 can my stock harness be modified to run the 5.3 if so is there a guide out...

1991 Formula Firebird 89Kmi. Complete drive train transplant from wreck 2001 Trans Am. Mods: Comp XE 216/216 .577/.577 114LSA cam Yank SS3600...

Hi there all im new here and this is my first topic: Im about to start a swap project for my gmc Yukon GT (2door) 99 with 5.7 vortec engine as of...

I'm swapping an lm7 into my '93 k1500. I'm to the point of being ready to drop the motor in and would just like some advice before I tackle it in...

My 5.3 is a 99 do I need to keep this fuel Vapor canister for my setup what about the lines thanks

What are you doing to keep the AC lines from sweating and dripping all over the coils? It's no show truck but I really don't want to have to wrap the...

Jl8806's AvatarJl8806 , Today 07:29 AM I'm almost finished with my 5.3 swap into my 97 chevy k1500 but I'm having a little trouble with the active....

Question is what do i need to do to do this, someone said a 4l80e spacer...anybody's input would be great