Forum: LSX Truck Conversions

My plans 1) 4link truck so I can keep back seat 2) install ls1 383 stroker / 4l60e 3) redone the to all black 4) remove all bags 5) make it more...

I have a 05 silverado with a 5.3 in it now. I found a good deal on a good running ls1. I know I can bolt my intake, exhaust and oil pan on and...

To those of you that used the stock 95 4l60e and bolted it to a 5.3 did you have to rewire the 13 pin plug at all because I looked at a 1995 plug...

i was strolling around the local u pull it junk yard and found a 1999-2002 silverado with a v6 and a 5 speed standard i was wondering if this trans...

I was wondering why my truck has a spacer plate between the acc brackets and the engine? There is only one of them, and it is almost an inch thick...

I have a question on how to tie in my trans lines to my radiator. I put an 05 5.3 and 4l60e in my 96 sierra. I am using my 96's radiator and the...

Ok, I am still very new to this forum and hope I can get some informative input on what just happened. I posted my introduction a couple a days ago...

so i finally picked up a 6.0 for my 85 c10 put it is just a short block so no heads and i am trying to figure out what set of heads i was to go with...

Will the factory 5.3 y pipe fit in an obs truck like a 1995 GMC sierra with a 4l60e 4wd. I would like to use the stock 5.3 pipe if possible? If not...

Wondering if anyone here has used this kit on a OBS? The price is alot better than I can find on the camaro oil pan that I used on my swap when I put...

I know due to the background "LS1"truck lol of the site but ill ask anyways. So I have a 1985 silverado I received from my father been in family...

I've a 97 ecsb c 1500 and Ive repined my harness to run the 0411 computer.I was wondering which ls 4l60 has the same wiring and plugs as my 97 4l60?...

I know its not a truck but its getting a truck motor and I dont hang to much on ls1tech, thirdgen or fbody sites so ill do it here. Car is currently...

Can some one suggest what clutch, throw out bearing and pilot bearing should be ran I have a 4.8 flywheel by the way. Finally finishing my project

time for my factory/cobbled tbi bracket to go bye bye. tired of its ugliness and belt squeak from less-than-perfect alignment. between josh powers...

I'm about to tackle my second swap soon, 1999 Tahoe 2wheel drive 2 door, whats the best reasonable way to keep the A/C?? I did a swap before on my 94...

I was thinking of getting an electric water temp guage and putting the sender unit in a bung on the radiator. Will I get an accurate reading there? I...

I have a 2000 silverado with a 5.3 and im doin a tbss intake manifold, fuelrail, and injector swap. i figured out i need injector adapters. and i was...

I'm working on a 5.3 swap into my 97 chevy sub. can someone suggest some headers? thanks

Hey there guys... I'm pretty new on here... And I need some help.. My 92 k1500 with 360kms just pretty much died... motor oil is running out the...