Forum: LSX Truck Conversions

My friend and I were prepping my engine and installing a new oil pan.. he noticed the driver side rear manifold bolt was broken and there were signs...

ok so im goin to get the 4.8 next week end i wont to find one with a nv3500 from the factory but all i have found are 4l60 backed. i will be using an...

I have found some info on wiring the speedo and cruise to the pcm but how does the abs get its signal from the pcm if i get rid of the drac box?...

Anyone done one any help would be great thank guys

I've read about all the mounts with a 1" setback to allow for original driveline usage. Does this apply to the 4L80E also? Most info I'm seeing...

Which rear axle is suggested to use? It has the stock 8.5" 10 bolt GM axle still in it, I want to change the gears so I figured it was a good time to...

Hey LS fans im currently working on swapping a 5.3 into a 97 chevy suburban I orderd some motor plates from wisner machine works off of ebay....

Can I keep these two items functional?? If so what extras do I need to ask to be added to my new harness?? Will I need to keep the current 98 model...

Ok so recently got a crashed gmc short bed. Got the whole truck. Pulling the motor and Trans to put in my panel. It's a drive by wire (so no cable to...

I'm looking for a set of headers for my 95 ls1 conversion. can anyone tell me what works the best; and, or, what I have to do to make them work....

I've looked around for a little while and i'm having trouble finding the brake booster fitting for the intake from a 5.3 engine.. I called my local...

I've read that you can eliminate the charcoal canister. Question is what is the proper way to do it? If I just plug the intake port then there is an...

I started laying out my newly converted wiring harness on the engine to do some clean up and tie up loose ends. I found a plug that runs down the...

Took her around the block a few times for the first check ride after many start-ups in the driveway to tweak and adjust stuff. Got on the gas a...

I wanted to sort through what factory wires are in the cab of my 94' silverado. I am trying to identify which wires I will need to make my factory...

im new to this fourm ...i just finish a 95 silverado 2012 6.0 swap. everything works but my brake lights and my 3rd brake light stays on even...

Hey all, so I pulled my engine and trans today. I plan on installing the new engine and my old trans tomorrow. I got stopped today because I couldnt...

My plans 1) 4link truck so I can keep back seat 2) install ls1 383 stroker / 4l60e 3) redone the to all black 4) remove all bags 5) make it more...