Forum: LSX Truck Conversions

ok so im trying to figure out what a good price to list my truck for sale would be but i dont know where to start.. its a 2001 silverado 1500 4x4 std...

Have any of you guys used the underhood fuse box for the 94 to 98 trucks to fuse the harness. There seems to be plenty of room in there and am...

Well after getting a ride in my brothers turbo 4.8 I just couldn't resist!! I sold the engine and trans out of it and now have most of the money to...

I am using a PSI harness with programmed 411 pcm... I was looking over the pinouts on the original pcm and noticed the AC system controls run thru...

Anyone tried any of the dual 11 inch fans on ebay?? Any other suggestoins to cool a stock 5.3 in my swap on my 98 tahoe?? It already has the large...

Well started over on GMT400 and dont seem much help so thought I would throw my build up over here too. Got a 91 RCLB from my dad. 258k 5.7...

I'm still green to my own swap but as far as efans go, I have a 2000 6.0 with a clutch fan goin in to a 96 OBS tahoe. My PCM last I looked didn't...

I have a 91 gmc that is going to be street legal I have a psi harness and PCM and I was told to keep the stock abs wires turn signals wiper motor etc...

hey everyone so im new to this site and i need a little help on my first swap that i have just started so my friend brought me his single cab...

I am so close to driving my truck I can taste it. I have the LM7 in and the carb conversion is complete. I have a TPS sensor wired to the carb, I...

My friend and I were prepping my engine and installing a new oil pan.. he noticed the driver side rear manifold bolt was broken and there were signs...

ok so im goin to get the 4.8 next week end i wont to find one with a nv3500 from the factory but all i have found are 4l60 backed. i will be using an...

I have found some info on wiring the speedo and cruise to the pcm but how does the abs get its signal from the pcm if i get rid of the drac box?...

Anyone done one any help would be great thank guys

I've read about all the mounts with a 1" setback to allow for original driveline usage. Does this apply to the 4L80E also? Most info I'm seeing...

Which rear axle is suggested to use? It has the stock 8.5" 10 bolt GM axle still in it, I want to change the gears so I figured it was a good time to...