Forum: LSX Truck Conversions

Anyone know how or if the 2 pin truck alternators can be used without the pcm controlling them? Is it as easy as just adding a resistor like the 4...

well hello all im new to this forum i have been jumping from different forum doing alot of reading as im putting a 6.0ls into m 1990 chevy c1500. a...

Hey guys, I have a 1997 GMC Sierra 1500 Z71 with the 5.7 vortec and 4L60E with 385k miles on the motor. I have the opportunity to buy a wrecked 2013...

I just purchased a 86 c-10 with a 5.3 swap and can’t get Dakota cruise unit to work this computer stuff is new to me what must I do to get it working...

2008 6.0/4L80 installed in a 78 C10. original starter, worked fine. Bendix gear goes out - buy a replacement starter, install, turn key and a...

Hi all new to the forum. Got a 2003 silverado with 4.3 that i plan on putting in 5.3.. Got another 2003 donor truck thats complete runs and drives...

I have an 05 Denali AWD crew cab im dropping an l92 408 in and figured it would be sweet to 6 speed it what all would be involved?

i am fixing to start my ls1 swap in my 88 obs, its 2wd, no tach, im putting a built 700r4 back in it with the rv cable conversion from bowtie and...

Quick question for you guys, does anyone know if 1996 Chevy 7.4 Vortec exhaust manifolds will fit a 5.3L? They appear to fit a little more snug than...

Hi. I can't find the white wire from my 97 Harness that originally went to ECM C3-9 from the Coil for the engine speed signal. On the 5.3 computer...

doing a rebuild and a swap on a old 5.3 truck. have a new block going in the truck with some regular 243 heads going on them (going to rebuild the...

New to the site but have been searching for some information for a while now. Just bought a 2013 RCSB with the 4.3 V6 and 4L60E. Truck only has...

I want to put a 5.3 in my 97 4x4 tahoe and was wondering if those headers would fit?

Ok Beginning Phase of my Mental Swap. Im tryna wrap my mind around the electrical. Whats the best way to get my swap electrical done. Im not...

hey all, first post here. this is my first LS swap. i've got a 2003 LM7 with about 80K, i've added an LS9 cam a92mm throttle body and I was told...

95 rcsb sierra that had a v6 swapped in a 6.0/4l80 with sliding dirty dingo mounts. What 4l80 yoke do i need? I have 2 different ones and niether of...

1989 C1500 with an 05 5.3, drive by wire throttle, R4 AC Compressor. I didn’t have any AC issues before the Swap, I left the Compressor hooked up...

finished up my swap about 2 months ago and have been driving it pretty often. hour drive to work or pulling my trailer with quads and dirtbikes. Only...

Any help is really appreciated, I have a 1995 Chevrolet z71, originally had the 5.7 tbi with the 4l60 trans. My plan is to take everything from a...