+ Post New Thread
Page 38 of 209 FirstFirst ... 28 36 37 38 39 40 48 88 138 ... LastLast
Threads 741 to 760 of 4169

Forum: LSX Truck Conversions

All LS Based Conversions

  1. PCM Programming question.... Fuel gauge and AC

    I bought a harness and programmed PCM, got it in the truck and running.. It is in a 1998 2 wheel drive tahoe, when i did the install I unpinned all...

    Started by 1991SSP‎, 07-03-2013 07:11 AM
    • Replies: 3
    • Views: 2,169
    07-03-2013, 04:37 PM Go to last post
  2. Gathering parts and info for the swap

    Here is the pics of the truck and the engine maybe I should leave it in the box it gives me the desirede ride height in the rear lol. this will be...

    Started by 94RCSB‎, 12-30-2011 08:00 PM
    • Replies: 37
    • Views: 10,000
    07-02-2013, 11:43 AM Go to last post
  3. Pressure plate bolts?

    I'm swapping a 2003 lq4 into my 89 k1500 with a nv3500. I'm getting ready to drop my engine in and I just realized that I don't have any pressure...

    Started by SlowAndHighTBI‎, 06-26-2013 04:02 PM
    • Replies: 4
    • Views: 2,574
    06-29-2013, 04:23 PM Go to last post
  4. 97 c1500 cruise cable

    Are these cables ajustable? I read that it should hook right up to my 5.3 thottle body but its a short, it snaps right in the bracket but wont reach...

    Started by chevy_addicted‎, 06-23-2013 10:53 PM
    • Replies: 8
    • Views: 2,965
    06-27-2013, 07:52 PM Go to last post
  5. 95 4l60e

    I am in the middle of a 5.3 swap and am using my 95 trans the bellhousing cover doesnt fit anymore so I am assuming that I am supposed to trim it to...

    Started by gta87305‎, 06-03-2013 09:56 PM
    • Replies: 7
    • Views: 2,672
    06-24-2013, 10:05 PM Go to last post
  6. Need help with MAF

    Hey guys, I'm swapping a 2003 lq4 out of an Express 3500, into my 89 k1500. I have a question about my mass air flow sensor. The MAF from the...

    Started by SlowAndHighTBI‎, 06-23-2013 10:14 AM
    • Replies: 3
    • Views: 2,375
    06-24-2013, 04:55 PM Go to last post
  7. My 1994 Blazer lq4/4l80e swap

    I picked this blazer up back in 2011 for $700, it was very dirty and had an extreme lack of maintenance, but the body was relatively straight and the...

    Started by slow94‎, 06-12-2013 10:57 AM
    • Replies: 8
    • Views: 3,828
    06-23-2013, 07:12 PM Go to last post
  8. 94 k1500 vortec 5.3 swap??

    so i got a complete running donor truck for motor and trans but i was wondering if some of you guys who have already done this swap could help me out...

    Started by smokeshow89‎, 05-02-2013 12:25 AM
    • Replies: 2
    • Views: 4,605
    06-23-2013, 03:51 PM Go to last post
  9. adding a trans cooler

    So I am in the middle of the swap and i got a trans cooler out of a chevy pickup between 96 and 99. The problem is on my truck there are 2 5/16 lines...

    Started by gta87305‎, 06-16-2013 08:13 PM
    • Replies: 4
    • Views: 2,026
    06-22-2013, 09:27 AM Go to last post
  10. LS7 lifter tick. Only ticks around 2k rpms. Doesnt tick at idle. HELP

    I have been driving on my new setup for a couple hundred miles now, and I can def hear a lifter tick right around 2000 rpms. It wont tick at idle...

    Started by HPICamaroSS‎, 06-06-2013 06:49 PM
    • Replies: 10
    • Views: 9,005
    06-19-2013, 12:06 PM Go to last post
  11. No Reverse

    K I did an LQ4 swap and am using my stock 4L60E and I have no reverse. Have hooked up the Tech2 and found my PRNDL switch shows the gear change. But...

    Started by 1duffman‎, 05-24-2013 10:23 AM
    • Replies: 14
    • Views: 4,480
    06-16-2013, 02:35 AM Go to last post
  12. Holley r4 bracket with 5.3 swap

    Has anyone else used the Holley R4 bracket with their swap I am trying to use the factory lines and the one that bolts to the compressor the low side...

    Started by gta87305‎, 06-10-2013 05:24 PM
    • Replies: 9
    • Views: 4,004
    06-15-2013, 10:45 PM Go to last post
  13. my transmission is squeeling lq9/th400 swap

    I just swapped a lq9 into my 1990 chevy. I went with a msd 6010 and performer intake. I Bolted it to a th400. I have a dished flexplate. This was my...

    Started by jwang203‎, 06-14-2013 01:31 AM
    • Replies: 5
    • Views: 3,860
    06-14-2013, 02:41 PM Go to last post
  14. 84 c10. Need info on gauges.

    How is every one playing with this style truck doing your gauges? Can this swap work with factory or do I need to look in another direction? I'm...

    Started by Onelow_10‎, 06-09-2013 01:37 AM
    4.8 gauges c10 84
    • Replies: 2
    • Views: 1,813
    06-09-2013, 04:38 PM Go to last post
  15. Shift cable too short on 98 tahoe which mtr mounts will keep trans in stock position

    got my 98 tahoe swap complete except for the trans cable, I had some dirty dingo mounts that were supposed to be for my tahoe, not so sure now if...

    Started by 1991SSP‎, 06-06-2013 12:21 PM
    • Replies: 8
    • Views: 3,103
    06-08-2013, 12:13 PM Go to last post
  16. 2003 Z71 AVY 5.3 to 6.0 swap

    I did a search on this here, I went back 20 pages. Not much detailed info to find. Owners with experience please respond here. If you go to the link...

    Started by Avarookie‎, 06-03-2013 01:07 PM
    • Replies: 3
    • Views: 2,271
    06-04-2013, 12:15 AM Go to last post
  17. No power after swap! Horsepower that is.

    Guys I'm so frustrated with how this whole swap has gone, I literally hate this truck! Here's the details tell me what you think. Ideas on what to...

    Started by dimebagged‎, 05-28-2013 09:34 PM
    • Replies: 14
    • Views: 5,182
    06-03-2013, 10:51 PM Go to last post
  18. Need Help Identifying Power Steering Ports

    Hello! I swapped a 5.3 into my 1997 Ford F150. I'm down to the power steering hose hook ups. I'm using a 2000 Silverado PS pump. I thought I figured...

    Started by Bilster‎, 05-30-2013 04:18 PM
    • Replies: 2
    • Views: 1,681
    05-30-2013, 06:08 PM Go to last post
  19. LQ4 into '83 K2500, looking for suggestions.

    Hello everyone, I've been reading and researching LS engines for several months now. I have a 2000 LQ4 with ~200k miles on it that was a running...

    Started by 83GMCK2500‎, 05-19-2013 03:05 AM
    • Replies: 7
    • Views: 2,874
    05-28-2013, 02:12 AM Go to last post
  20. shifter problem on 1998 Tahoe swap

    Anyone that has done the swap on a truck with cable shifter ran into any problems?? I have a brand new cable from advance auto,, The shifting is...

    Started by 1991SSP‎, 05-18-2013 02:06 PM
    • Replies: 2
    • Views: 1,699
    05-18-2013, 04:49 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts