Forum: LSX Truck Conversions

Hey guys, we're doing a swap here. We started last week or so and just wanted to share. This truck belongs to a member on the site. This truck is...

just trying to verify that f-body headers will work on 73-87 OBS trucks? i have tried to ask specific guys about the headers they are using, but...

Everything has lined up great but a few little snares have set me back a little bit. For one, the temperature sender that I pulled out of the...

Here it is...

I am going to buy a 5.3 and 4l60e with 30,000 miles, is this a good deal?

i cant send you PM's for some reason. check your personal settings. everything should be there ready for install. the injectors were...

I love these gauges but a grand??? Thats a bit much. Is there a better way or do I bite the bullet once again? Will this be easier than getting the...

I'm putting a cammed 6.0 in my 82 silverado. It has a Th350 and 456 gears. The cam is a 226 and stall is 3000. I wanted to put the victor Jr on...

Is there any manual transmissions that are made for the 5.3 vortecs???is a t56 an option??

Hello folks, A&A Corvette is building me a nice engine that will have about 800HP on a long body all wheel drive Escalade weighing about 6000lbs I...

Got it up and fired last night, broke in the cam and drove it to work this morning. Like every project there had to be a hiccup and I found it last...

I've been a member for a short time now, and I've been wanting to do this conversion for a couple years. I've noticed that there are a lot of...

I just bought a tranny from a '00 camaro (4l60e) and i'm wondering what linkage I will need to make the actuator work. When I bought my truck it had...

I'm putting a 5.3 in place of a tbi 4.3 in my 1991, I know I have to change to sbc mounts. Will these adapters work for what i need?

looking for a/c compressor and alternator for ls1 swap into 79 1/2 ton. can i use old 350 stuff? or do i need to find ls1 accessories to go with...

Sheesh after a month of weekends after buying my 2005 5.3/4L60E we finally got it all working. It was hard with the wiring since not many people have...

I have searched and found conflicting information, it seems that the Gen III engines will run without a vss but some say that there are some problems...

I have had a wire harness made for my 2004 K2500 HD Transfercase so that I could plug it into my truck along with the 6.0 and 4l80e. I have wire...

First off I'd like to say thanks to everyone on here. I've gotten a lot of good information on here for the OBS to 6.0 swap. It's made me alot more...

ok here goes, I own a 1983 chevy silverado c10 lwb. I really love perfromance, and my lil 350 4 blt main just isnt cutting the mustard anymore. ...