Forum: LSX Truck Conversions

ok so here is the problem this time. i decided to put in the 4L80E which came with the motor i have the 2004 LQ4 instead of using the turbo 350 which...

I am getting ready to do my 6.0/4L80 swap in my 1990 2WD truck, can i use the truck oil pan? and if so how far below my Xmember will it set? I am...

I've searched and found the cable needed if I was using the Drive by cable but what all is needed to keep cruise control with a drive by wire setup?

in tryin to get my budget together for my 5.3 and/or 6.0 swap, im wondering what ya'll as running for exhaust setup? i would like to do it right the...

What is easier to do? a carb setup 5.3 swap in a OBS truck or a fuel injected setup 5.3 swap in a OBS? I know how to set up carb motors really well...

Just checking eBay nice 87 with LS2 eBay Motors: Chevrolet : C/K Pickup 1500 (item 320269764219 end time Jul-08-08 18:58:43 PDT)

Thinking of doing a 04' z06 motor swap on my 03 sierra with the 5.3. i'm pretty sure all i'll have to do is reuse my intake manifold,headers and oil...

im new to the forum and was wondering if anyone could possibly help me with tuning my truck. it was tuned fine until yesterday when i did a cam...

I wanted to start a new thread so we can document the length and types of factory driveshafts. I need a one piece replacement for my two piece unit...

as far as i understand it, 03+ had electronic throttles? Given this engine (if i get it) will be going into my 94 z71 which is obviously cable...

I have ? about the wiring harness for my swap. Would I be able to adapt my 03 02 sensors to my 2002 wiring harness?

Just thought this might spark some questions and ideas for others. This one is a low rider swap we're doing. ...

Just picked up a tranny cooler from out of a Eldorado, it a plate type cooler not sure of what the rating is, but wondered if it was a big enough...

ok heres the deal I have a bad transmission in my 96 gmc 2wd 5.0/auto truck. I have found a 5.3/auto 2wd out of a 03 chevy pickup that I could...

So far I have removed from the Blue PCM connector 23, 25, 28, 32, 65, and 68. From the Red PCM connector 4, 7, 13, 36, 37, 44, 53, 54, and 64. What...

Ok need some help. I am putting a 5.3 into a 1983 Jeep CJ8 Scrambler. The motor I bought is from another fellow jeepers project that didn't get off...

Can I use the O2 sensors from my 97 on the new 5.3 or will I have to buy new ones?

Where is a good place that has some reasonable prices on wiring harness for a 5.3 motor swap into a 1992 chevy with a 700r4 tans. i just need a...