All LS Based Conversions
Which sensors do I need to pull off my old motor to go on the 5.3? I am thinking I need the oil pressure sensor (located next to the distributor) and...
Lance or Red or anyone else...Why is my fuel pump burning out fuel pump relay after fuel pump relay? Installed a new fuel pump already. No go....
How big of a cam can you run with a stock stall converter in a 4l80? I know that they are bigger than the ones in the 4L60 but I didn't know what...
I'm looking for anyone who has an '87 or older and has done a conversion. If you could post setups, thoughts, experience, notes, prices, parts......
I am dreading the wiring on this project, the thread about the guys not starting has me confused and worried at the same time. How much splicing do I...
On nelson wiring harness the wire labels "chmsl supply voltage/stop lamp supply voltage" what does this go to? I'm assuming it something to hookup...
I have my swap almost done but i am running into a few issues 1. I can start the truck but it runs only for a few seconds. I did send my PCM in so...
Heres what I have. 96 gmc 1500 that had 5.0/auto. swapped in 03 5.3/auto. With nelson wiring/pcm hooked up get nothing with the key. If I put...
So in a rush to get my engine swap done I made a HUGE! mistake. I accedentally cut out my neutral safety switch wiring harness and removed the wiring...
I ordered a 160* thermostat for my 03 5.3 and of course its the wrong one. Looks as though the thermostat and housing are 1. I've noticed that...
Its finally going back together!
long tubes will be available in about a 6 weeks! Ding Ding Ding Ding... Come And Get It!!!! - Page 2 - S-10 Forum
:givemebeer: :givemebeer: :givemebeer:
I have a 5.3L Chevy single cab shortbed fourwheel drive. Im trying to decide if i want to turbo or procharge. Daily driver, reliability is a must....
my youngest brother is putting the finishing touches on his 96 gmc, it has a 5.3 installed and ready for life. one issue that caught him off...
Okay heres the deal. My brother drives a 07 nbs silverado with a 5.3. He is wanting to put an ls2 in it. How hard would that be? I heard they drop...
I've been reading up on some E85 conversions that some guys over on ls1tech and a guy on a local board fastrides have been doing. Has anyone...
what would be the benefit on going to the larger engine? how possible is it to upgrade the 4x4 parts to make it them hold up to the power? that would...
Ok i am new to this site so i will apologize now for possibly asking some dumb questions. I have a 92 regular cab short bed with a 5.7L TBI, i just...
To all who notch their frames for the a/c compressor. What was the thickness of the metal used to make your notch?
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
