+ Post New Thread
Page 3 of 65 FirstFirst 1 2 3 4 5 13 53 ... LastLast
Threads 41 to 60 of 1281

Forum: Electrical

Powertrain | Body | Chassis

  1. I/P blank after swap. BCM getting power.

    00' 4.3 to 03' 5.3. All plugs (C2, C100, C152) are pinned to schematic. Key in on position, I/P blank except MIL light. Key in on position with scan...

    Started by AllBlackSierra‎, 01-26-2015 09:06 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 3,002
    02-09-2015, 12:36 AM Go to last post
  2. Drive by wire to Drive by cable conversion

    As most of you kn ow by now i have a complete pullout with ECm and all wiring from a 01 yukon that is drive by wire. I am looking to convert to drive...

    Started by altereddezignz‎, 09-03-2014 04:21 PM
    • Replies: 5
    • Views: 2,048
    02-02-2015, 10:08 PM Go to last post
  3. O2 sensor and alternator variances?

    So were all familiar with case grounded and isolated ground O2 sensors on the Gen3 stuff. It seems that any LS1B PCM will work with either style,...

    Started by vortecyota‎, 02-02-2015 05:05 PM
    • Replies: 8
    • Views: 1,763
    02-02-2015, 09:23 PM Go to last post
  4. 4L60 to 4L80 swap question

    I received the ISS sensor harness from Nelson, and I am having a bit of trouble inserting the pins into the ECM. Is there a specific procedure for...

    Started by jetmech‎, 01-26-2015 05:48 PM
    • Replies: 7
    • Views: 2,330
    02-02-2015, 08:42 PM Go to last post
  5. Question Red pin #33

    Hello, I have a 2002 Sierra 4X4 5.3.---- tuned by Allen. Question is- does and at what temperature does the PCM red pin #33 activate? Also Blue...

    Started by metalchips‎, 01-19-2015 08:56 PM
    • Replies: 2
    • Views: 1,247
    01-20-2015, 02:11 PM Go to last post
  6. windshield wipers behaving badly

    I've got a wierd problem with my wiper motor. Wipers work but they dont turn off when I shut them off, eventually they will turn off but usually in...

    Started by exboatracer‎, 11-06-2014 09:45 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 2,359
    11-20-2014, 08:40 AM Go to last post
  7. Is the big gray coil pack plug needed?

    Hi. I am working on the wiring for the 5.3 I am installing into my 97 Tahoe. I am trying to route and hide everything I can. Is there any reason...

    Started by lovesdunes‎, 11-09-2014 06:27 PM
    • Replies: 2
    • Views: 1,054
    11-09-2014, 11:28 PM Go to last post
  8. 02' S10 4.3 Vortec 4x4 Ls1 5.7l Swap pinout and wiring diagrams

    Hello all, I am sure this info is in a thread somewhere, but there are so many threads to read that my Obsessive/compulsive disorder will not allow...

    Started by eddieg769600‎, 11-04-2014 07:59 PM
    • Replies: 0
    • Views: 1,062
    11-04-2014, 07:59 PM Go to last post
  9. Rewiring 99 tahoe windows with new switched and new relays non factory

    Got a question here about some wiring. I have non of the factory wiring in the gutted 99 2wd tahoe that i just purchased. I have made up my mind to...

    Started by altereddezignz‎, 09-15-2014 02:08 PM
    • Replies: 0
    • Views: 1,001
    09-15-2014, 02:08 PM Go to last post
  10. 99'-02' 4.3l C2 fuse block pinout diagram. (Descriptive)

    Looking for a descriptive pinout for the c2 block. I have the std pinout diagrams, they describe most of the circuits, but they only describe a few...

    Started by AllBlackSierra‎, 09-12-2014 02:12 PM
    • Replies: 0
    • Views: 1,309
    09-12-2014, 02:12 PM Go to last post
  11. E-fan wiring?

    I have the factory 05' Silverado dual fans installed on my truck, are these fans single or dual speed fans? I am not sure whether I need to wire them...

    Started by Bear‎, 03-07-2014 11:23 PM
    • Replies: 9
    • Views: 2,932
    08-26-2014, 10:53 PM Go to last post
  12. Need helps

    I swaped to a 4l80e and I checked my truck for codes because when I went to put in gear the the gear selecter on the dash said it was in reverse but...

    Started by LQ4-TURBO‎, 08-04-2014 12:14 AM
    • Replies: 5
    • Views: 3,330
    08-14-2014, 05:11 PM Go to last post
  13. Cool Body Harness swap questions..

    I'm going to try and describe this the best I can.. And before you guys Say I should just buy a truck with all the options I wanted, keep In mind I...

    Started by Nocturnal Performance‎, 05-21-2014 10:17 PM
    body harness, interior swap, power window swap, swap, v6 to v8 swap
    • Replies: 0
    • Views: 2,523
    05-21-2014, 10:17 PM Go to last post
  14. Blinker prob

    I'm sure there is already a post on this but I can't find it.. But ok i can't figure this out and I need help I have a 2001 silverado my blinkers...

    Started by SS-PEREZ‎, 04-25-2014 01:05 PM
    • Replies: 6
    • Views: 2,444
    04-29-2014, 09:13 PM Go to last post
  15. Remote start and keyless entry

    I'm in need of a new keyless entry and I won't to go ahead and get a remote start and keyless entry all in one. I found a refurbished one ebay model...

    Started by LQ4-TURBO‎, 04-26-2014 01:35 AM
    • Replies: 3
    • Views: 1,951
    04-28-2014, 09:44 PM Go to last post
  16. Cam sensor

    Anybody ever have a cam sensor issue? If so what problems did it cause

    Started by bootlife‎, 04-27-2014 11:31 AM
    • Replies: 5
    • Views: 1,787
    04-28-2014, 04:31 PM Go to last post
  17. Nelson Engine Harnesses

    Hey, My name is Roy and I am the new wiring Tech at "Nelson Performance" we are currently building engine harnesses again. If anyone has any...

    Started by Roy@NP‎, 10-23-2013 11:37 AM
    • Replies: 5
    • Views: 2,293
    04-23-2014, 04:46 PM Go to last post
  18. is 9145 bulb size the same as 9006???

    As the tittle says thanks

    Started by EL SRG‎, 04-23-2014 02:00 AM
    • Replies: 1
    • Views: 1,618
    04-23-2014, 03:54 PM Go to last post
  19. MSD 8969 help

    Ok guys I'm stumped I've searched and can't find my answers I'm looking for. I bought the MSD8969 window switch I'm wanting my 2nd stage nitrous to...

    Started by SS-PEREZ‎, 03-30-2014 10:32 PM
    • Replies: 5
    • Views: 1,679
    04-03-2014, 02:26 PM Go to last post
  20. Help a homie out.

    I am about at the wits end gentlemen. Finally got my 80e swap done. Got the "correct" segment for my PCM. Because my PCM apparently has se kind...

    Started by Show&Go‎, 03-31-2014 05:54 PM
    • Replies: 4
    • Views: 1,526
    04-01-2014, 09:58 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts