+ Reply to Thread
Results 1 to 3 of 3

Thread: Anxiety over a yoke

  1. #1
    Join Date
    Jun 2018
    Posts
    4

    Anxiety over a yoke

    95 rcsb sierra that had a v6 swapped in a 6.0/4l80 with sliding dirty dingo mounts. What 4l80 yoke do i need? I have 2 different ones and niether of them work. Both are too short. Someone out here has done this i need your help plz!!

  2. #2
    Join Date
    Jun 2018
    Posts
    4
    Anyone? Bump

  3. #3
    Join Date
    Mar 2013
    Location
    Long Beach California
    Posts
    637
    After I did my 80e swap, I had to have my drive shaft shortened about an inch or so due to the trans being a bit longer. Not sure why yours are too short. do you have the adjustable DD motor mounts? Maybe the motor needs to be slid back a bit...??
    Like Tumbler in "Gone in 60" I'll drive anything with wheels or without

    My 95 ECSB LQ9 build thread - http://www.ls1truck.com/forums/lsx-t...to-95-obs.html
    CALI LEGAL ENGINE SWAP!
    Stock 03 LQ9, DBW, 95' 4l80e w/ Transgo shift kit, 2010 50# GM injectors, 2800 Circle D stall, Spectre CAI, Upgraded trans cooler, Home-made E-fans/shroud, Dual EP-381 fuel pumps w/Home-made hotwire kit
    NEXT ON LIST: Dual Battery setup, CAM/Valvetrain upgrade, Build my own rear mount turbo, TRU-TRAC, HIT THE STRIP!!!

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts