+ Reply to Thread
Results 1 to 3 of 3

Thread: Missing on all cylinders in cammed Tahoe

  1. #1
    Join Date
    Feb 2014
    Location
    livermore, CA
    Posts
    10

    Missing on all cylinders in cammed Tahoe

    Ok guys,

    I have an 05 Tahoe that has about 6k on it since rebuild. About two weeks ago I got a stumble while driving in town and the dreaded flashing check engine light. When hooked up to a scan tool initially I had a MAP sensor code, so I replaced it. Needles to say that didn’t fix the issue. I am having misfires on all cylinders. Ran a smoke machine, and no visible vacuum leaks. Cats are both good, and no backpreasure measured. Fuel pressure was good.

    What the hell can be causing this? At normal driving RPM’s engine runs horrible, but seems to clear up at higher RPMs. Doesn’t matter if it’s cold or hot, runs horrible. Tahoe was dyno tunes months ago and was running flawless. Has some detonation sounding pinging when giving gas at lower RPM too. I’m at a loss.

  2. #2
    Join Date
    Mar 2003
    Location
    San Marcos Texas
    Posts
    4,393
    Sounds like it is super lean. Try disconnecting the mass air sensor and see how it runs. You need to log it!

  3. #3
    Join Date
    Nov 2009
    Location
    SAN ANTONE
    Posts
    781
    were you able to scan the truck to see what the issues were?
    06 rcsb, 6two, 231/235, 4.11, pacesetter, 80e, 14 bolt, Nelson tuned
    2011 rcsb 6two swap in the works with 6l90 and boost
    FARMTRUC CAN GARGLE PEANUT BUTTER

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts