anyone willing to let me use their balancer intaller tool in the dfw area, willing to give a 12 pack
anyone willing to let me use their balancer intaller tool in the dfw area, willing to give a 12 pack
Auto zone and orreilies should have one ask for the big one tho.
ECSB 2kSierra 2wd 4.8L-K&N-HPtuners-Calspeed LT's-Magnaflow-Tahoe20's-HankookRH06
waiting to go in... 3.90s, 214/220cam
I'll have the hammer and 2x4 ready, just bring my 12 pack!
i already tried both and they dont work with ls motors,
i was trying to make my own its just that would be cheaper to buy one instead, and im trying to avoid that since i wont use it again.
what part of DFW? It is a huge place.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
over by arlington
Put the balancer in the oven for a little while. Works like a champ for me. Iv used this method half a dozen times with no problems
2008 GMC Sierra SLE....370ci LY6 with some goodies SOLD
1995 C2500- LS1 swap with a mp112
build thread- http://www.ls1truck.com/forums/lsx-t...-ls1-swap.html
I bought 14mm x 2 pitch allthread, a nut and four washers to do mine with. Put grease on the threads and between the washers and it works great. Bought it all at fastenal.
What part of arlington? I am at 360 and brown blvd when at work. Arlington is right on the other side of 360 from me.
Last edited by RedHeartbeat; 07-18-2012 at 09:08 AM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709